Sanyo LNS-S02 Replacement Procedure

Sanyo lns-s02 projector-lens: install guide

Download this manual

LCD PROJECTOR LENS

MODEL NO. LNS-S02

LENS REPLACEMENT AND

INSTALLATION PROCEDURE

Lens installation should be performed by the qualified service personnel.

It should be followed by this procedure precisely.

Before attempt to install the lens, confirm the model number (both the LCD

projector and the lens) and use the proper lens.

If you have any questions, contact to the dealers.

Following checks and confirmations should be taken for safety.

Check the following things by the time of the cabinet assembly after the

lens installation.

1. Confirm the lens is securely fixed by 4 screws.

2. Wiring must not be tangled in the gear of the lens motor or the other

mechanical part.

3. There is no missing part, or no loosing mounting part.

NOTES ON LENS INSTALLATION

PARTS LIST

Following parts are contained in the packing.

· LENS

· LENS MOUNTING SCREWS

· DRIVER

· LIGHT-BLOCK SHEET

1 piece

6 screws (2 for spare)

1 piece

1 sheet

1AA6P1P1981-- (ICPE)

Page 1: Parts List
LCD PROJECTOR LENS MODEL NO. LNS-S02 LENS REPLACEMENT AND INSTALLATION PROCEDURE NOTES ON LENS INSTALLATION Lens installation should be performed by the qualified service personnel. It should be followed by this procedure precisely. Before attempt to install the lens, confirm the model number (both the LCD projector and the lens) and use the proper lens.
Page 2 LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps REMOVE THE LENS COVER. (See figure-1) Remove screws A (2 screws). Pull down the lower lens cover while pushing the part D, then remove it. Remove screws B (2 screws). Remove screws C (2 screws) and remove upper lens cover.
Page 3 Figure shown inside of the cabinet. INSTALL THE LIGHT-BLOCK SHEET. (See figure-5) Install the light-block sheet around the lens as shown in the illustration. (Use the sheet included with the lens.) Set the light-block sheet, so that the large rounder side is set over the lens.