Multifunction On-Screen Displays - Fisher FVH-E439 Operating Instructions Manual

SU4/UF2 (FVH-E439 GB) Tue. Feb. 09/1999

MULTIFUNCTION ON-SCREEN DISPLAYS

Various displays appear, superimposed over the screen
image, indicating the operation mode and features in use.
Operation mode
QTR end time
p QTR10:30PM
SPORTS DIGEST
SP 0:00:00
Recording
tape speed
Counter
Operation Mode Display
When an operation button is pressed, the corresponding
operation mode icon is displayed in the top left corner of
the screen for about 3 seconds.
NOTE:
The recording pause mode icon will remain
displayed until recording is resumed or stopped.
Operation Icon Operation
Play Record
c
Fast-forward Record pause
c c
Rewind
d d
Channel Number Display
The channel number display appears for about 3 seconds
when a channel is selected.
Program Title Display
When a channel is tuned or when normal playback is
started, the program title (maximum 24 characters) will be
displayed for about 4 seconds.
NOTES:
œ The program title is only displayed if the broadcast
carries the title information or if it has been recorded on
the tape.
œ Depending on the TV signal or tape condition the
program title may not be displayed even if it is available.
Status display
1
Program title
Channel/AV
C 10
09:30PM
Clock
2
NOTE:
displayed on screen, or during special playback.
Remaining Tape Duration Display
Icon
1
a
a h
2
NOTES:
œ The remaining tape duration display will not appear if a
œ This feature will not work properly on T-140 tapes or
œ Depending on the condition and type of tape used, the
17
Press the DISPLAY button on the remote control.
The status display appears.
SP 0:00:00
To remove the status display, press the DISPLAY
button (press the button twice if a tape is loaded in
the VCR).
The status display will not appear if a menu is
Press the DISPLAY button twice.
The remaining tape duration appears at the bottom
of the screen. It is calculated in hours and minutes
from the current position to the end of the tape.
SP Tape remain
If " --:-- " is displayed, the remaining tape
duration has not been calculated.
To remove the remaining tape duration display, press
the DISPLAY button again.
menu is displayed on screen or during special playback.
tapes longer than T-160. (The feature will work on
T-160 tapes.)
VCR may not accurately detect the remaining tape
duration.
C 10
09:30PM
2:30