Brakes - Sanyo DTL4800 Basic Service Technical Information

3-12-4.T SOFT BRAKE ASSEMBLY, TAKE UP REEL
ASSEMBLY, T REEL GEAR (See Fig.3-12-4)
1) Remove the T soft spring
2) Remove the clamp
assembly .
3) Refer to section 3-12-2 and remove the clutch mount-
ing assembly.
4) Pressing the T brake assembly
the arrow, remove the take up reel assembly
the T reel gear .
ASSEMBLY NOTE:
1. After cleaning the shafts
(VHJ-0099) to each.
T reel gear
T brake
assembly
Shaft
Shaft
.
, then remove the T soft brake
in the direction of
and , apply a drop of oil
Take up reel
assembly
T soft brake
assembly
T soft
spring
Clamp
Fig.3-12-4

3-13. BRAKES

3-13-1.S BRAKE ASSEMBLY, T BRAKE
ASSEMBLY, T BRAKE ACT SLIDE
(See Fig.3-13-1)
1) Refer to section 3-3-1 and remove the cassette mecha-
nism assembly.
2) Remove the two clamps
and
brake act slide
assembly
moving the T brake act slide
3) Remove the brake spring
4) Remove the two clamps
remove the T brake assembly
5) Remove the clamp
assembly
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the shafts
2. When fitting the T brake act slide
with the shaft
Brake spring
S brake
assembly
Shaft
–20–
, then remove the T
. (Note: You can remove the S brake
and the T brake assembly
.)
.
simultaneously, then
.
, then remove the S brake
.
, align the mark
.
Mark
Clamp
Clamp
Shaft
Clamps
without re-
and .
T brake act slide
Clamp
T brake
assembly
Shaft
Fig.3-13-1