Craftsman CMXLSBWP5 - 450-Lumen LED Rechargeable Spotlight Manual

INTRODUCTION

Read this Instruction Manual and follow the instructions carefully before using your new spotlight.

FEATURES

1. LED bulb
2. Rubber bezel
3. On/off trigger
4. Grip handle
5. Micro-USB charging port (for use with the USB Charging Cable)
6. Battery/charge status LED indicator
7. Translucent waterproof end cap (see detailed view in the "Reading the Battery/Charge Status LED Indicator" section)
8. Rubber O-ring
9. USB charging cable
10. Regular USB plug
11. Micro-USB plug

READING THE BATTERY/CHARGE STATUS LED INDICATOR

The battery and charging status LED indicator is located directly above the micro-USB charging port under the waterproof end cap on the back of the unit.

It lights or flashes in three colors to indicate the following:

When charging:

Green: Battery is in a fully charged state.
Green (flashing): Battery is in a high partially charged state.
Orange (flashing): Battery is in a low partially charged state.
Red (flashing): Battery needs to be recharged.
Red (flashing rapidly): The battery of the unit is overheated due to extensive use or recharging. The charging process will stop at this stage and will automatically resume after a cool down period.

When operating:

Green: Battery is operating at full voltage.
Orange: Battery is operating at partial voltage.
Red: Battery is operating at low voltage, and should be recharged or the built-in low voltage protection will be activated and the unit will automatically shut down shortly.
Red (flashing rapidly): The battery of the unit is overheated (due to extensive use or recharging), or is too cold (the ambient temperature has dropped below -20°C). Operation will stop at this stage.

CHARGING/RECHARGING THE SPOTLIGHT

This unit is shipped in a partially charged state. Charge unit after purchase and BEFORE first use until the battery/charge status LED indicator lights green.

Recharge after each use until the battery/charge status LED indicator lights green.

When the unit is not in use, we recommend that the battery is charged at least every 3 to 6 months.

TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:

• Make sure the unit is thoroughly dry before charging or recharging. If the unit has been submerged, wipe it dry with a soft cloth before opening the end cap. If water leaks into the charging port, the unit can sustain permanent damage.
• Never place the light face down on any surface when charging.
• Failure to keep the battery charged will cause permanent damage and result in poor performance.

Charging/recharging using the USB charging cable and a device with a USB power port (not supplied)

1. Make sure the spotlight is off.
2. Unscrew (counterclockwise) the waterproof end cap on the back of the unit and remove it.
3. Insert the micro-USB plug of the USB charging cable into the micro-USB charging port on the back of spotlight.
4. Insert the regular USB plug of the USB charging cable into a device's functional USB power port. The battery/charge status LED indicator will light or flash in one of three colours (as described in the "Reading the Battery/Charge Status LED Indicator" section) to indicate the charging status.
5. Charge until the battery/charge status LED indicator lights green.
6. When charging is complete, disconnect the USB charging cable from the device's USB power port and the spotlight. Store the cable in a safe place.
7. Replace the end cap on the unit, screwing clockwise until the triangular arrow on the end cap is pointing to the dot icon on the rear of unit. Make sure it fits securely, but do NOT overtighten.

OPERATING THE SPOTLIGHT

The On/Off Trigger turns the unit on and off, and is also used to choose either the high or low brightness setting.

DO NOT OPERATE WHILE CHARGING.

Disconnect the charging cable or adapter, then select the light mode as follows:

• Press the On/Off trigger once to use the spotlight in its high (brightest) setting.
• Press the On/Off trigger again within 5 seconds to use the spotlight in its low (dimmest) setting.
• Press the On/Off trigger a third time to turn the unit off.
  or
• Press the On/Off trigger once to use the spotlight in its high (brightest) setting.
• Press the On/Off trigger again after 5 seconds to turn the unit off.

Note: The battery/charge status LED indicator will light in one of three colors (as described in the "Reading the Battery/Charge Status LED" section) to indicate the battery status. It is visible through the translucent waterproof end cap.

CARE AND MAINTENANCE

All batteries lose energy from self-discharge over time and more rapidly at higher temperatures. When the unit is not in use, we recommend that the battery is charged at least every 3 to 6 months.

If the unit gets dirty, gently clean the outer surfaces of the spotlight unit with a soft cloth moistened with a mild solution of water and detergent.

There are no user-replaceable parts. Periodically inspect the condition of adapters, connectors and wires. Contact manufacturer to replace any components that have become worn or broken.

Battery replacement/disposal

BATTERY REPLACEMENT

The battery should last the service life of the unit. Service life is dependent on a number of factors including but not limited to the number of recharge cycles, and proper care and maintenance of the battery by the end user. Contact manufacturer for any information you may need.

SAFE BATTERY DISPOSAL

Contains a lithium-ion battery, which must be disposed of properly. Recycling is required. Failure to comply with local, state and federal regulations can result in fines, or imprisonment.

Please recycle.

• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.

TROUBLESHOOTING

The spotlight will not charge

• Check that the spotlight is turned off.
• Check the connection to the spotlight and the power source. Make sure there is good contact.
• Make sure the power source is functioning properly.
• The unit may have shut down to protect the battery from overheating after a long period of operation or charging. Unplug the USB charging cable from the power source and the spotlight. Allow the spotlight to cool down for a period before resuming charging.

The spotlight will not operate

• Make sure the On/Off Trigger has been pressed to turn the spotlight on.
• The internal battery may be completely discharged. Charge the unit following the directions given in this manual.
• The unit may have shut down to protect the battery from overheating after a long period of operation or charging; or the ambient temperature has dropped below –20°C. Allow the spotlight to cool down or warm up for a period before resuming operation.
• If the ambient temperature is too hot or too cold the spotlight will not operate.

If the unit does not charge or operate after taking the steps given above, contact the manufacturer at 888-331-4569.

ACCESSORIES

Recommended accessories for use with your tool may be available from the manufacturer. If you need assistance regarding accessories, please contact the manufacturer at 888-331-4569.

The use of any accessory not recommended for use with this appliance could be hazardous.

SERVICE INFORMATION

Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at 888331-4569.

SPECIFICATIONS

Light

Bulb: 5 watt LED bulb
Battery: Lithium-Ion, 3.6 V DC
Input: 5V DC, 1A

To purchase optional accessories, contact the manufacturer at 888-331-4569.

Imported by Baccus Global LLC,
One City Centre, 1 North Federal Highway, Suite 200, Boca Raton, FL 33432
www.Baccusglobal.com 888-331-4569
RD091018