Sample air flow approximately 1-2 minutes to get an accurate reading. Record Oxygen and/or Carbon Monoxide readings. Note: Carbon Monoxide levels not to exceed 10ppm, oxygen range 19.5% - 23.5%. Air Systems International, Inc. 821 Juniper Crescent Chesapeake VA 23320 Page 2 Revision 2 April 2000...
Page 3
HUTDOWN 1. Close bottle valve. 2. Disconnect sample hose from box and adapter. 3. Open bleed valve. (Turn counterclockwise). 4. Remove AQT-347LP from bottle Air Systems International, Inc. 821 Juniper Crescent Chesapeake, VA 23320 Page 3 Revision 2 April 2000...
Page 4
Allow digital readout to stabilze. turns counterclockwise. turning the knob counter- clockwise until the flow ball hovers in the "green bar area" (50-100 cc/min). Air Systems International, Inc. 821 Juniper Crescent Chesapeake VA 23320 Page 4 Revision 2 April 2000...
Page 5
A 30 - 60 minute and coupling. restabilation of the sensor(s) may be required if the batteries are removed for more than 1 hour. Air Systems International, Inc. 821 Juniper Crescent Chesapeake, VA 23320 Page 5 Revision 2 April 2000...
Page 6
Turn the unit on and allow 30-45 minutes for the sensor(s) to stabilze. STEP 6) Calibrate meter. STEP 3) Install sensor leads onto new sensors and re- place in their respective cups. Air Systems International, Inc. 821 Juniper Crescent Chesapeake VA 23320 Page 6 Revision 2 April 2000...
Page 7
EPLACEMENT TEMS Air Systems International, Inc. 821 Juniper Crescent Chesapeake, VA 23320 Page 7 Revision 2 April 2000...
Need help?
Do you have a question about the AQT-02 and is the answer not in the manual?
Questions and answers