Do you have a question about the SR-3500 and is the answer not in the manual?
Questions and answers
denis leboeuf
May 10, 2025
sanyo sr-w4500(m) errror code e4 I need to replace control board? If right where i can found it Thank you
1 comments:
Mr. Anderson
May 20, 2025
Error code E4 on the Sanyo SR-3500 typically indicates a defrost sensor or temperature sensor issue, not necessarily a control board failure. Before replacing the control board, check the defrost sensor and wiring for faults. If the sensor and wiring are working correctly and the error persists, the control board may need replacement.
The control board is usually located behind a panel at the rear of the refrigerator or inside the control housing at the top of the fresh food compartment. Disconnect power before accessing it.
Need help?
Do you have a question about the SR-3500 and is the answer not in the manual?
Questions and answers
sanyo sr-w4500(m) errror code e4 I need to replace control board? If right where i can found it Thank you
Error code E4 on the Sanyo SR-3500 typically indicates a defrost sensor or temperature sensor issue, not necessarily a control board failure. Before replacing the control board, check the defrost sensor and wiring for faults. If the sensor and wiring are working correctly and the error persists, the control board may need replacement.
The control board is usually located behind a panel at the rear of the refrigerator or inside the control housing at the top of the fresh food compartment. Disconnect power before accessing it.
This answer is automatically generated