Advertisement
Quick Links
Product Description
The B0129 RF Transceiver Module is a compact surface-mounted module for multi- channel RoLa
operation in the 2400 MHz ISM band. The module is completely shielded and pre-certi ed for
operation under US radio regulations for license-free use.
Technical data
Frequency
Modulation method
Channel bandwidth
Supply voltage
Temperature range
Dimensions
FCC ID
FCC ID
Block Diagram
1.8-3.7 V
SI
RF
SCLK
SO
Tranceiver
RESET
CC1200
GPIO
CSN
GND
Pin Assignment
VCC
SI
SCLK
SO
RESET
GPIO
CSN
GND
The nal host product must be submitted to SHUN
HU Technology Co., Ltd. for con rmation that the
installation of the module into the host is in
compliance.
with the regulations of FCC and IC
Canada. Speci cally, if an antenna other than the
model documented in the Filing is used, a Class 2
Permissive Change must be led with the FCC.
2.4GHz
RoLa
500KHz
1.8-3.7 Volt
-40°C+85°C
30.38×18.5×7.45(mm)
RN489896162-B0129
RN489896162JK915
TCXO
52Mhz
Theory of Operation/Technical Description
- RF circuit function:
The major part of this IC is a
transceiver.
- RF signal ow:
The Control signal is encoded into a Data Stream to be the
modulation input for the transceiver.
-Description of Antenna system:
The antenna shall be connected to the RF pin. The RF pin is
matched to 50 Ohm. If the antenna connector is placed
away from the module at the motherboard, the track
between the RF pin and the connector should be a 50 Ohm
transmission line.
GND
ANT
Filter
GND
User Manual
Model: B0129
2401-2478
MHz compliant
Advertisement
Related Manuals for Juuko B0129
Summary of Contents for Juuko B0129
- Page 1 Model: B0129 Product Description The B0129 RF Transceiver Module is a compact surface-mounted module for multi- channel RoLa operation in the 2400 MHz ISM band. The module is completely shielded and pre-certi ed for operation under US radio regulations for license-free use.
- Page 2 User Manual Mechanical Drawing Antenna gain: 2dBi 18.5 14.2 Label FCC Part 15 * This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation * You are cautioned that changes or modi cations not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
- Page 3 LABELING AND USER INFORMATION REQUIREMENTS The B0129 module has been labeled with its own FCC ID number, and if the FCC ID is not visible when the module is installed inside another device, then the outside of the nished product into which the module is installed must also display a label referring to the enclosed module.
Need help?
Do you have a question about the B0129 and is the answer not in the manual?
Questions and answers