Gear Light S2000 - LED Flashlight Manual

PACKAGE CONTENTS

• 1x GearLight S2000 LED Flashlight
• 1x AA Battery Holder (Inside Flashlight)
• 1x Lanyard
• 1x Operation Guide
• 1x Warranty Card

FLASHLIGHT OVERVIEW

To avoid eye injury, do not stare directly into the light beam or shine the beam directly into anyone's eyes. This product is not designed, intended, or recommended for children or hazardous environments.


Always follow the battery manufacturer's instructions as to the proper usage, handling, storage, and disposal of batteries. Use only batteries from a reputable manufacturer. Do not mix different brands or types of batteries in the same flashlight. Replace all batteries at the same time. Immediately remove batteries from a defective flashlight. Failure to follow safety instructions may result in personal injury and damage to property.

GETTING STARTED

AA Battery Installation

1. Unfasten tail cap and remove battery holder.
2. Insert 4 AA batteries following the correct polarity (+,-) marked on the battery holder.
3. Insert the battery holder back into the flashlight with the positive (+) end first.
   
   

The flashlight may become warm or hot after extended periods of use at the highest setting. Select a lower setting when the flashlight is hot. This is typical for high-powered flashlights and does not cause damage to the flashlight.

OPERATION

On/Off

• To turn the flashlight on, press down firmly on the red power button located on the tail of the flashlight until you hear a click.
• To turn the flashlight o, press down firmly again until you hear a click.
  

Switching Modes

• There are 5 different lighting modes. (High, Medium, Low, Strobe, SOS)
• To switch through the different lighting modes, gently press down on the red power button to alternate through the 5 modes.
• The flashlight will switch to the next mode when turned off and on in quick succession. It will reset back to the highest mode after being off for more than 10 seconds.

Zoom

1. Hold both ends of the flashlight; gently twist and pull each end away from the other.
2. Pull the two ends away from each other to zoom in and push the two ends together to zoom out.
   

TROUBLESHOOTING

If the flashlight does not turn on, or works intermittently:

• Replace the batteries.
• Make sure the tail cap is twisted on tightly and batteries are inserted correctly.

If the flashlight flickers or changes modes automatically:

• Make sure the tail cap is twisted on tightly.

If light appears dim or faded:

• Replace the batteries.

If problem persists:

• LED Failure. Contact GearLight for replacement.

Irvine, California | USA | www.GearLight.com