Cadillac GMC Yukon Denali 2005 Owner's Manual page 234

q r
SEEK : Press the right or the left arrow to go to
the next or to the previous track on the CD.
q r
SCAN : Press and hold either arrow for more
than two seconds until SCAN appears on the display
and you hear a beep. The radio will go to the next track,
play for 10 seconds, then go on to the next track.
Press either SCAN arrow again to stop scanning.
BAND: Press this button to listen to the radio when a
CD is playing. The inactive CD(s) will remain safely
inside the player for future listening.
TAPE DISC: Press this button to play a CD, if a CD is
loaded in the changer and the radio is on.
Press this button to switch between playing a tape and
a CD in the CD changer, if both are loaded.
CD Changer Errors
CHK CD (Check): If this message appears on the
display, it could be for one of the following reasons:
•
It is very hot. When the temperature returns to
normal, the CD should play.
•
You are driving on a very rough road. When the
road becomes smoother, the CD should play.
3-96
•
The CD is dirty, scratched, wet, or upside down.
•
The air is very humid. If so, wait about an hour and
try again.
•
There may have been a problem while burning
the CD.
•
The label may be caught in the CD player.
•
The CD player is very hot.
Notice: If you add paper labels to a CD, insert more
than one CD into the slot at a time, or attempt to
play scratched or damaged CDs, you could damage
the CD player. When using the CD player, use
only CDs in good condition without paper labels,
load one CD at a time, and keep the CD player and
the loading slot free of foreign materials, liquids,
and debris.
If the CD is not playing correctly, for any other reason,
try a known good CD.
If any error occurs repeatedly or if an error cannot be
corrected, contact your GM dealer. If the radio displays
an error message, write it down and provide it to
your GM dealer when reporting the problem.