Page 3
INDEX Diagram Features of the appliances Technical data 4 Installation instructions 4.1 Safety rules 4.2 Structure, framework and safety devices of the appliances 4.3 Assembly 4.3.1 Installation premises 4.3.2 Statutory regulations and technical requirements 4.3.3 Installation 4.3.4 Wiring 4.3.5 Equipotential 4.4 Preparing for installation Operation preparation 5.1 Preparation and Start-up...
Page 4
1 - DIAGRAM Fig. 1 F H C B IBE4 11.5 11.5 IBE4 Terminal board Yellow indicator light (resistance) Knob Cable input Equipotenital Drainpipe Switch Data plate Screw 503_03 - ELECTRIC BAIN-MARIE 4 · 15...
THE APPLIANCE MUST BE INSTALLED BY QUALIFIED PERSONNEL. 3 - TECHNICAL DATA Voltage rating Model Dimensions in mm. Power Lead wire / Section (LxPxH) IBE4 400 x 610 x 220 230 V 1.0 kW 3 x 1.5 mm 503_03 - ELECTRIC BAIN-MARIE 5 · 15...
4 - INSTALLATION INSTRUCTIONS 4.1 Safety rules 4.3.2 Statutory regulations and technical requirements During installation of the appliance, the following regulations must • Installation, modifications and maintenance of the appliance be adhered to: must be carried out by authorised personnel in compliance with •...
4 - INSTALLATION INSTRUCTIONS appliance, it is necessary to waterproof the leaks with sanitary silico- Panels and/or inflammable parts must be at a distance of at least ne, anti-mould and heat resistant to at least 100°C (i.e. Pactan 6076). 300 mm from the hot walls of the machine. The knob position is fixed;...
5 - SET-UP FOR OPERATION 5.3 Ignition Check if the water discharge is closed. Fill the vessel with water to the relevant mark. Turn on the main switch upstream of the applian- Turn on switch (pos. 1 fig. 6) of the appliance, come on shows that the appliance is on and with knob (pos.
6 - INSTRUCTIONS FOR USE 6.1 Safety, cleaning and repair rules 6.3 Appliance care and frequency of maintenance • This appliance is used for the preparation of meals at industri- Attention! When cleaning, carefully avoid washing the al level. Usage and cleaning can be carried only by expert per- appliance with direct water jets or high-pressure sonnel.
Page 13
6 - INSTRUCTIONS FOR USE • contact with non-ferrous metals (element build up) 6.4.3 The 2002/96/EC (WEEE) Directive: • lack of oxygen (i.e. no air inlet, water lacking oxygen). information to users This informational note is meant only for Fig. A owners of equipment marked with the 6.4.2 Warnings and advice for maintenance of stainless symbol shown in fig.
Need help?
Do you have a question about the IBE4 and is the answer not in the manual?
Questions and answers