Emay SleepO2 User Manual

TM
SleepO2
Sleep Oxygen Monitor
User Manual
This product is intended only for general wellness use. It is not a medical
device and should not be used to diagnose or treat any medical
condition.

1. Introduction

1.1

Warnings and Cautions

 DO NOT squeeze the sensor part or apply excessive force
on it.
 Do not use this device during MRI examination.
 Never submerge the device in water or other liquids. Do not
clean the device with acetone or other volatile solutions.

Do not place this device in pressure vessels or gas
sterilization device.
 Consult your doctor immediately if you experience
symptoms that could indicate acute disease.
 Do not self-diagnose or self-medicate on the basis of this
device without consulting your doctor. In particular, do not
start taking any new medication or change the type and/or
dosage of any existing medication without prior approval.
 Use only cables, sensors and other accessories specified in
this manual.
 Prolonged continuous monitoring may increase the risk of
undesirable changes in skin characteristics, such as irritation,
reddening, blistering or burns.
1.2

Unpacking

Main Unit × 1
Charging Cable × 1
User Manual × 1
1.3

Overview

Wear the device during sleep. It protects you
from oxygen shortage by Smart Vibration.
Oxygen drop Smart Vibration Oxygen recover
Next morning, you can get the sleep results and
O2 Score in App to help you track.
You can customize Smart Vibration in App to
help you sleep better.
2

Using the Monitor

2.1

Download App

App name: Check O2
iOS: App Store
Android: Google Play
2.2

Charging

Charge the battery before using.
Connect the device to USB of computer or USB
charging adapter.
After fully charged, the device will power off
automatically.
2.3

POWER ON/OFF

POWER ON:
Press the button on the side for 1 second to turn on
the device.
POWER OFF:
Recommended way: device turns off automatically
in 2 minutes if no measurement, no operation,
without App connection.
Manually: press the button for about 2 seconds to
turn off.
2.4

Typical steps

START. Charge the battery.
Wear the device, press the
button to power on. Go to sleep.
STOP. Next morning, take off the
device, the recording will be over
after the countdown.
DATA SYNC. After the
countdown, run App to sync
data. Check results in App.
2.5

Start monitoring

1) Wear the device on the
forefinger. If it is too tight,
try another finger.
2) Turn on the device. After a
few seconds, the device will begin to monitor.
(If the working time is less than 1 minute, the
data will not be saved)
Note:
• Please avoid excessive motion for the sensed finger during
recording and avoid any strong ambient light condition.
2.6 Stop monitoring & sync data
Take off the device, the countdown
will begin.
(If the working time is less than 1 minute, there will
be no countdown)
During the countdown, if you wear the device again,
the record will be resumed.
After the countdown, the data will be ready for
sync.
Sync data:
1) After the countdown, run App to sync data;
2) Or next time after you turn on the device, run
App to sync.
Note: The device can store maximum 4 records.
The oldest record will be overwritten when the 5
record is coming in. Please sync data to your phone
in time.
th