Advertisement
Quick Links
Advertisement
Related Manuals for ABACUS Challenger 1 LED-1500W
Summary of Contents for ABACUS Challenger 1 LED-1500W
- Page 1 INSTALLATION MANUAL Challenger 1 LED-1500W V2.0...
- Page 2 READ AND FOLLOW ALL SAFETY INSTRUCTIONS. SAVE THE MANUAL FOR FUTURE REFERENCE! WARNING To avoid electric shock: Installation and wiring of luminaire must be in accordance with all applicable local codes. Installation, inspection, and maintenance of luminaires should be performed by a qualified electrician. DO NOT make or alter any open holes in the luminaire.
- Page 3 OPTION 1 – Overslung installation • • Install the floodlight on the mounting bracket with an Install the driver onto the driver mounting M20 (grade 8.8 or higher) nut and bolt (max torque brackets with the bolts included. settings 500Nm) •...
- Page 4 • Tighten the glands to cables to the torque settings below: • Connect the DC output cables to the relevant driver o M25 gland – 5Nm terminal blocks, as shown below. o M20 gland – 3.5Nm • Close the driver terminal cover with the 4 No. T20 torx bolts (torque settings 1.6Nm) Blue Brown...
- Page 5 OPTION 2 – Overslung and underslung installation • Loosen the M14 ① and M8 ② bolts on both sides of the floodlight bracket. ① ② • Rotate the bracket as shown below.
- Page 6 • • • Install the floodlight on the Install the driver on the top Lower the bottom floodlight as mounting bracket with an M20 floodlight’s driver mounting shown below and install the (grade 8.8 or higher) nut and bolt brackets with the bolts included. driver mounting brackets with the (max torque settings 500Nm) bolts included.
- Page 7 • • Tighten the glands to cables to the torque settings Connect the DC output cables to the relevant driver below: terminal blocks, as shown below. o M25 gland – 5Nm o M20 gland – 3.5Nm • Close the driver terminal cover with the 4 No. T20 torx bolts (torque settings 1.6Nm) Blue Brown...
- Page 8 OPTION 3 – remote driver installation • Connect a new DC input cable of sufficient length and • Open the floodlight junction box. connect it as per below (max cable length 200m). • • Disconnect the DC input 8 wire cable Use new M25 gland if required (not included).
- Page 9 • • Install the DC output cable with gland ① to the Connect the DC output cables to the relevant driver driver (gland to body torque settings 3.43Nm) terminal blocks, as shown below. • Install the Surge Protection Device ② Blue Brown White...
- Page 10 CONNECTIONS DC input 1500W 1 single cable for NTC. H07RN-F8×1.0mm DC output Dimming/DALI Blue Brown AC input White Black Gray DC output Purple Dimming/DALI Purple Gray Yellow/Green Inline Connectors AC input Yellow/Green Blue Brown AC input Supplied surge protection device must be installed to maintain the warranty and replaced if faulty.
- Page 11 DC input 1500W 1 single cable for NTC. H07RN-F8×1.0mm DC output Dimming/DALI Blue Brown AC input White Black Gray DC output Purple Dimming/DALI Purple Gray Yellow/Green Inline Connectors AC input Yellow/Green Blue Brown AC input Supplied surge protection device must be installed to AC 230V maintain the warranty and replaced if faulty.
- Page 12 Mintenence There are no consumable parts to replace in this product and it should be disposed off at the end of its life in accordance with the WEEE directive The product should be inspected annually and cleaned with a non-aggressive product. Any deterioration in the cables should be noted and reported to a suitably qualified electrician who will advise an appropriate course of action.