Bosch WGG244010 Instructions For Use And Assembly page 46

enTroubleshooting
Disturbance
Change program duration
changes during the
washing process.
Water is not visible
in the drum
bar.
Drum jerks
program start.
In the chamber
there is residual
ser.
vibration and movement
the appliance during
spinning.
drum turns,
Water doesn't run in.
strong foaming
dung.
high centrifugal
number is not
reached.
46
Cause and troubleshooting
A notice:When loading, put as large and small items of
laundry as possible together in the drum. Items of
laundry of different sizes spread out better when
spinning.
Foam control system switches on a rinse cycle if the
foam builds up too much.
No error - no action necessary.
▶
Water is below the visible range.
No error - no action necessary.
▶
Do not add additional water to the device during
▶
operation.
The cause is an internal engine test.
No error - no action necessary.
▶
be
Insert in chamber is clogged.
→ "Cleaning the detergent drawer", page 36
▶
Device is not aligned correctly.
→ "Align device", page 17
▶
Device feet are not fixed.
Fix the device feet.
▶
→ "Align device", page 17
Transport locks are not removed.
→ "Remove transport locks", page 14 .
▶
Load detection is active.
No error, no action necessary.
▶
A notice:The load detection can take up to 2 minutes.
Detergent dosage is too high.
Immediate measure: Mix a tablespoon of fabric
▶
softener with 0.5 liters of water and pour the
mixture into the left chamber (not for outdoor,
sportswear and down textiles).
For the next wash cycle with the same load, reduce
▶
the amount of detergent.
Low spin speed is set.
Set a higher spin speed for the next wash cycle.
▶
Easy ironis activated.
Select suitable programs for the type of fabric.
▶