Advertisement
Quick Links
Advertisement
Summary of Contents for 360 Hunting Blinds SHANTY HUNTER
- Page 1 ASSEMBLY MANUAL...
-
Page 2: Parts List
SAFETY DISCLAIMER At no time shall 360 Hunting Blinds be liable for any accidents due to normal or improper use of blinds or tower stands. We recommend that you follow standard safety procedures when entering and exiting the blind, or climbing or decending the ladder. - Page 3 STEP 1 INSTALL THE LEGS Install 8” – 12” 4x4s into the pockets on the fl oor and secure with 3 – 3” deck screws per foot. If you purchased a tower stand you may skip this step. STEP 2 INSTALL THE CARPET Align the carpet roll to the edges of the blind fl...
- Page 4 STEP 3 INSTALL THE FIRST PANEL Set the fi rst panel into place. Have one person hold the top of the panel while another person aligns the bottom. Make sure the corners of the panel match with the corner of the fl oor and that the panel doesn’t gap away from the fl...
- Page 5 STEP 5 INSTALL SECOND PANEL Start at the top of the panel, align the tops and outsides of the panels to make sure they are even. Then work down the panel keeping everything together and running several screws while going down. Be sure to use the 2 1⁄2”...
- Page 6 STEP 7 HOIST THE ROOF Lift the roof to the top of the blind and rest it on the walls. Balance it on the rear walls far enough to have room to install the fi nal wall panel and door panel.
- Page 7 STEP 9 FASTEN THE ROOF Fasten the roof to the top of the wall panels. Center the roof on the blind, aligning the roof with the wall panel joints. Start above the door and screw through the top of the wall panel into the roof panel with SHORT screws, aligning as you work toward the back of the blind.
- Page 8 STEP 11 TOUCH UP Use the touch up paint to touch up any nicks or scratches that can occur during setup. Any unpainted siding will rot faster than painted siding so be particular when painting. 360HUNTINGBLINDS.COM PAGE 8...