Advertisement
STEP 1
1
STEP 4
12
10
x3
6
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1 Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place.
STEP 2 Align holes of Arms (7L & 7R) with holes of Seat Cushion (5), secure Arms (7L & 7R) using four Arm Screws (8) for each arm.
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (12).
STEP 3 Attach Seat Plate (4) to Seat Cushion (5) with the arrows facing the front of the chair, using four Seat Plate Screws (9).
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (12).
STEP 4 Insert Back Support (11) into rear of Seat Plate (4), and secure using three Back Support Screws (10).
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (12).
STEP 5 Insert Pneumatic Cylinder (3) into Base (1). Place the assembled seat on top of Pneumatic Cylinder (3) and apply downward pressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
STEP 2
2
8
x5
STEP 5
4
11
7600R / 7602R / 7605R
BIG MAN'S CHAIR
ASSEMBLY INSTRUCTIONS
12
x4
8
x4
7L
5
7R
3
STEP 3
12
9
4
5
PART
1. Base . . . . . . . . . . . . . . . . . . . . . . . 1
2. Casters . . . . . . . . . . . . . . . . . . . . . 5
3. Pneumatic Cylinder . . . . . . . . . . . . 1
4. Seat Plate . . . . . . . . . . . . . . . . . . . 1
5. Seat Cushion . . . . . . . . . . . . . . . . . 1
6. Back Assembly . . . . . . . . . . . . . . . 1
7. Arms (7L & 7R) . . . . . . . . . . . . . . . 2
8. Arms Screws . . . . . . . . . . . . . . . . . 8
9. Seat Plate Screws . . . . . . . . . . . . . 4
10. Back Support Screws . . . . . . . . . 3
11. Back Support (pre-installed) . . . . 1
12. Allen Wrench . . . . . . . . . . . . . . . . 1
© Office Star Products October 2012
x4
QTY
Advertisement
