Notes: If action between steps (a, b, c) takes longer than 30 seconds, the program will not complete. Simply start each step again at sub-step 'a.'
Up to 4 intermediate stops can be set by following Step 3 for each. IF the shade does not follow commands, DELETE all Memory (next page) and start over.
FCC Notice: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
AC-135 User Manual
(if you are adding multiple shades to a controller, see instructions at bottom of Page 2)
Page 1
AC-135 User Manual (page 1) 1. Link the Shade to the Remote Control (if you are adding multiple shades to a controller, see instructions at bottom of Page 2) c. Link to Remote a. Select the Channel b. Press/hold the Program button...
Page 2
Leviosa Shades Programming Instructions (page 2) Other actions Delete a limit position (the upper limit cannot be deleted unless all positions are deleted) c. After 1 second, the shade rotates a. Wait 30 seconds after last command. b. Use a paperclip briefly up and down.
Page 3
Leviosa Shades Programming Instructions (page 3) Motor Operation: Symptom Cause Solution After installation, the motor does not turn Motor not set in cradle properly Lift motor, and firmly seat into cradle The motor stops working System prevents overheating after After 10 minutes of non-use, the motor will many repeated cycles work again Wall adapter is unplugged, or...