Ezi Rider Vantage - Regenerative Charging E-Bike Quick Start Manual

INTRODUCTION

20 inches electric folding bike 300W, 36V 10Ah, Shimano 7 speed gears
Remember to switch key off after use
Tyre Pressure Front 45 lbs rear 50lbs
Includes a powerful 36V 11 amp Li - Ion Battery and can travel 50km on a single journey with Power alone, but Pedal Assist and Regenerative charging, gives a far longer range depending on the terrain.

ABOUT THIS UNIT

Shocks: Zoom
Battery: Samsung Cell made in Korea assembled by Ananda China 36v 11Ah Li-ion
Motor and electronics: Ananda
Handle Bars and controller: Wuxing
Gears and gear train: Shimano
Frame and component fittings: Kalin

What makes this Electric foldaway Bicycle better than others currently sold on the NZ market. It has front wheel Zoom fork shocks by HL Corporation. Quality welded frame, top quality components, the efficient brushless motor power train by the Ananda company and regenerative charging of which we are the first to introduce in NZ on the eziRIDER Vantage.

TYRES

Front Pressure = 45lbs / sq in
Rear Pressure = 50lbs / sq in

With an older type bike pump its very hard to inflate to this pressure but possible. Easier at the local garage unless you want to invest in a more substantial foot pump from Supercheap or Repco. Unfortunately, if you ride with soft tyres, there's a risk of rim and tube or tire damage should you hit a pothole or rock. The impact compresses the tyre, allowing the object to smack into the rim, possibly bending the rim and puncturing the tube. Besides this, it's much harder to pedal a bike with soft tyres, and the tyres wear quicker when used under inflated.

CLEANING and WASHING

Braking causes aluminum rims to oxidize, leaving a layer of grit that can contaminate brake pads. Depending on use and conditions particularly dusty, muddy, sandy or wet conditions you can wash down but, wipe your rims with a dry cloth.

Every third or fourth clean / wash, give your frame and fork a layer of car wax.
It restores the paint's luster and keeps road tar and bugs from sticking. The Shock absorber needs an film of oil or light grease. Chain can be kept lubricated by bike chain lubricant.

LEGAL THINGS NZ

In New Zealand the legal speed limit for power assisted bicycles is 32 km/h with maximum motor wattage of 300 watts. By law you need to wear a safety helmet and its advisable to wear bright colours. You are more safe when riding an electric bikes in NZ if you can keep up with the flow of city traffic rather than being slower and constantly overtaken. This bike will never leave you short of assisted speed and acceleration if you need it.
Assisted Cycle NZ Law Definition: A power assisted cycle has an auxiliary electric motor with a maximum power not exceeding 300W and is designed to be primarily propelled by the muscular energy of the rider.
Where there is a cycle path, you may ride on the cycle path or on the road. Where there is no cycle path, you must ride on the road and keep as far left as you safely can. If specifically prohibited by a sign from riding on the road, you must ride on any cycle path or use an alternative road. If you are cycling on a shared path, be courteous to pedestrians.
Often pedestrians can't hear cyclists approaching, especially from behind or the side. Call out politely or use the bell.

Features

New Model with Latest Design And Advanced Features
This Is A High Specification Advanced Bike
Auto Safety Cut off feature - When you press the Brake
Lever the Motor automatically cuts out
Shimano Gears
Quick Release Battery and locking system
On bicycle or Off Barrery charging Rear Servo Assisted Brakes
Rear Servo Assisted Brakes Front Tektro V Brakes
Full Front Wheel Suspension
Full Size Frame
Height Adjustable Handle Bars
Height Adjustable Seat
Latest Saddle
Zoom Suspension front forks
LED Lights Included
Double reflector pedals
50 Km + Range

Model Features:
Motor: 36v 300w
Battery: Ananda 36v 11Ah Lithium battery with Samsung battery components
PAS: Power Assisted plus Regenerative charging
Controller: Intelligent controller
Frame: 6061 Aluminum alloy
Speed Gears: Shimano 7-speed gears
Brake: Front Disk-brake, Rear Brake R-Servo
Tyre: Kenda 20" x 1.95 (note spare tubes Warehouse approx $7.00)
Rim: Double wall alloy
Lights: Front and Rear LED lights Charging time: about 2 hours
Battery Life: approx 1000 times charge
Range per charge: 50 Km + on Throttle, Peddle assist + Throttle 70km.
With Regeneration modes 1-3 much more km depending on terrain and rider.
Max NZ legal speed 32km/hr
Load capacity: 130Kgs
Weight: 24Kg with battery
Carton size: 87 x 37 x 78cm
Folded size: 90 x 30 x 70cm

Seven Speed Shimarno Gear change. Note you should not change through many gear settings while bike is stationary otherwise it will result in the chain coming off and crunching the mechanism. Its a good practice to end up in gear 1-3 when stopping so a startoff is easier to achieve. Practice on flat ground to ensure you are familiar with operation even before you start with assisted power. If the chain comes off, to get back on sprockets, is by rotating pedals backwards and guiding chain over the main power sprocket wheel.

Multi Mode Electric Bike:

4 MODE - ELECTRIC CONTROLLER

Modes 1-3 are for Self-Charging
Please do not use the Throttle

TO TURN ON THE BIKE LIGHTS
Press power button and then hold + button for 3 seconds.

When charging, the display on the battery balance will change from blue to dark red colour. Please see the below the two images.

PAS Regenerative Charging

1. Going down hill it charges the battery.
2. Flat road, as long as the required speed is exceeded, it charges the battery.

Setting Speed Charging request:
MODE 1 speed greater than 17km/h
MODE 2 speed greater than 21km/h
MODE 3 speed greater than 25km/h

3 easy steps

HANDLE BAR ASSEMBLY

Make sure handlebar is secured as per instruction on unit.
Finger pointing to Handle bar shaft folding lock / unlock mechanism.

MAIN FRAME FOLD

Lift lever and swing to left. When at 90 degrees then pin lifts up and the two parts can hinge so that the front folds together with the back wheel.

PEDALS can be folded by putting finger through centre oval hole in pedal and compressing in direction of the arrow.

CHARGING BATTERY

The battery can be checked for charge by pushing button on top of battery. If only RED light LED is the only one showing, then charging is needed. Depending on trips and distance will determine whether to charge. Two GREEN LEDS and a RED LED, the battery is charged to a suitable level. However the charger itself shows the true battery status when LED turns from RED to GREEN indicating a truly fully charged battery. It is suggested for the first 3 charges that the battery is left on charge for 12 hours even when GREEN is on the charger. When finished charging swing flap on battery to protect battery socket from dirt entry.

CHARGING SOCKET

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Ezi Rider Vantage - Regenerative Charging E-Bike Quick Start Manual