BRUMATE BruTank 35qt Quick Start Manual

BrüTank
Tips + Tricks
Ice Retention
Start with a chilled cooler and
chilled beverages
If the beverages you are putting into the BrüTank start out warm,
a significant amount of ice will be wasted cooling the cooler itself.
Preload your cooler a few hours prior to use with a sacrificial bag
of ice to cool it down or store it in a cool place before loading it up.
Ice temperatures vary slightly
Warm ice (around 32*F) is typically wet or dripping and won't
last long. Ice that is colder than freezing point is relatively dry
and will last substantially longer.
Air and sunlight are the enemy
Large areas of air inside your cooler will accelerate ice melt as
the ice is consumed with having to cool the air, instead of your
contents. If you do need to leave space in your cooler, they are
best filled with extra ice or beverages. Keeping the cooler out
of direct sunlight will also maximize ice retention.
Don't drain the water
Do not empty the cold water from the melted ice. The water
helps to insulate the remaining ice.
Rock salt is your friend
Using rock salt will super-chill your contents. Simply sprinkle
rock salt on top of the ice, close your cooler and enjoy extra
cold drinks.
Made For This Made For This Made For This Made For This Made For This Made For This Made For This Made For This Made For This
35qt
TM
How to Insert the Tank
Slide the tank into the cooler and ensure it is seated securely.
ProTip: You can also use the cooler without the tank to increase
ice capacity.
01
02
03
Once the tank has been installed, insert the tap
from the outside and hand-tighten until the tap
is facing vertically. Do not over-tighten.
To use the tap, press the button, and it will
activate the internal tap allowing liquid to flow
freely. When not in use, use the included spout
cover to keep it clean.
When removing the tank simply unscrew the tap
and lift the tank out of the cooler and witness the
magic of our self-tapping tank at work.