WALL'S REFRIGERATION SOLUTIONS Maxivision slim V Quick Start Manual

QSG Maxivision V Page 1
Point of sale
Wall's ice cream branded point of sale is available from P .O.S. Direct.
Warranty
Your cabinet is supplied with a 3 years parts and Labour warranty to protect you against
manufacturers defects. If you need assistance please call: 0161 366 2500
Wall's Refrigeration Solutions Customer Service Department on 0161 366 2500
In order to log a service call you will need to provide the serial number for the cabinet at
fault. This can be found on the information plate that is located on the back of the cabinet.
Use this space to make a note of the serial number for future reference using a ball point
pen:
SERIAL NUMBER
Please note that the basic checks detailed in this guide are usually excluded from the
warranty. See standard terms and conditions for further information.
Wall's Refrigeration Solutions reserve the right to charge for faults not covered by the
warranty.
If you are in any doubt contact our Customer Services Department.
Cabinet Contents Insurance
Please note that your cabinet warranty excludes any liability for loss of product or your
insurance excess no matter how caused.
We recommend that you check your Store Policy to ascertain if you are covered for such an
eventuality and if not then take separate insurance. It is recommended that you run your
freezer for 24 hours before placing stock inside.
Waste Electrical & Electronic Regulations (WEEE)
In accordance with the WEEE regulations Wall's Refrigeration Solutions is responsible for
the final disposal of all equipment purchased on or after the 13th August 2005 - customers
will be charged for the distribution costs at the time of collecting the unit.
For equipment purchased before 13th August 2005 Wall's Refrigeration Solutions
will make a commercial charge on the customer which covers both the disposal
of the unit(s) and the associated distribution costs.
Unilever UK Ltd T/A Walls Refrigeration Solutions, Trafford Park Road, Stretford,
Manchester M17 1NH Phone: 0161 366 2500
Sales enquiries: sales@wallsrefrigerationsolutions.com
Service enquiries: service@wallsrefrigerationsolutions.com
www.wallsrefrigerationsolutions.com
Quick Start Guide
Maxivision Slim V
Tel: 0845 600 6612
Quick Start Guide
Thank you for purchasing a
Maxivision V cabinet.
This guide is designed to ensure you
get the optimum performance from
your Maxivision V at all times.
By positioning and operating
cabinet correctly and then following a
few steps to look after it,
Maxivision V will run properly and
efficiently.
Positioning Your Cabinet
The cabinet should be positioned on a
•
flat, level surface and the levelling feet
wound down.
A 5cm gap must be left between the
•
sides and rear faces of the cabinet and
the wall or any other fixture or fittings.
The side and rear grilles must be
kept unobstructed at all times.
Please note the cabinet will not perform
•
in ambient temperatures over 35 C.
O
Operating Your Cabinet
The cabinet should be left to stand for 4
•
hours after delivery before being
plugged in for the first time.
The cabinet should be plugged into a
•
suitable 13 amp electrical supply. It
should be plugged directly into the
not
mains supply socket and
attached
to an extension lead or
adaptor.
Maxivision slim V
Picture may vary
the
your
Site the cabinet away from external
•
sources of heat, eg. radiators, direct
sunlight etc.
5cm gap all around
It will take approximately 24 hours for
•
the cabinet to get down to the required
temperature. Ice Cream should not
be put inside the cabinet until
temperature has been reached.
Once plugged in and switched on at the
•
mains supply socket it will begin to
Please note
work. that there is no on /
off switch.