Dolby Surround; Tuner - Samsung MAX-KDZ150 Instruction Manual

Dolby Surround

GB
Dolby Surround modes
Press the Dolby Surround button.
PRO-Logic is selected, and the playback sound has the Dolby
Surround effect.
To cancel Dolby Surround mode
Press the Dolby Surround button repeatedly until PASS is
displayed.
Dolby Surround
When playing DVD, if an Audio is Dolby Digital(multi-channel), it
can not be operated.
When being connected to headphones and microphone, this
function cannot be operated.
Additional Dolby Surround modes
In addition to the PRO-Logic mode, this unit is also equipped with the
3 STEREO modes.
PRO-Logic : Use this mode when rear speakers are connected. The
center channel signals are output through the left and right speakers.
3 STEREO : Use this mode when no rear speakers are connected. This
mode reproduces rear sounds through the front speakers.
PRO-Logic
Depending on the sound source or listening conditions, a surround
effect may not be obtained even when the Dolby Surround is on.
The full Dolby Surround effect cannot be obtained when using soft-
ware without
system instead.
1
4
7
Dolby Surround
Down
25
7 8 9
Program
SET
0 EQ Cancel/Clear
MO/ST
DVD-OK/DVD/TUNER
3 STEREO PASS
mark. In this case, use the DSP
DOLBY SURROUND
P R O L O G I C
2 3 Mute
5 6
Search Song
8 9 Program
SET
0 EQ Cancel/Clear
MO/ST
DVD-OK/DVD/TUNER
Up
Tuning
Enter
+
Volume
TAPE
Dolby Surround
Adjusting Speaker Level Balance
The unit is equipped with a built-in test signal generator called a
noise sequencer which outputs a noise signal that 'travels' from
channel to channel. This enables the simple adjustment of sound
levels, to achieve, at the listening position, the same apparent
loudness from each channel. Use the remote control.
1
Press the Dolby Surround button.
PRO-LOGIC" appears on the displayed.
Result: "
2
Press the Test Tone button.
A noise signal is sent to each channel in turn in the following
sequence.
L CNTR
(L : Left Speaker, CNTR : Center Speaker,
R : Right Speaker, REAR : Rear Speaker)
3
Press the Test Tone button again to stop the noise signal.
4
To change the sound levels or delay time after adjusting the balance
with the noise sequencer.
Press the Sound Edit button.
While L, R, CNTR, REAR is displayed, press the UP/DOWN
( / ) button to adjust the level:
L 0~-9,R 0~-9,CNTR -6~6,REAR -6~6.
Press the SPK Edit button.
While CNTR, REAR, DELAY TIME is displayed, press the
UP/DOWN ( ) button.
/
– CNTR : Large/Small/None
– REAR : USE/None
– DELAY TIME : 15/20/25/30 mS
When the Dolby surround system is on, this function can be oper-
ated.
Dolby Surround 0
1
DVD-OK/DVD/TUNER
Down
Tuning
Enter
Volume
TAPE
4

Tuner

Sound Edit
Band
Male/Female Step
Key Control
b
Tempo
R REAR
SET
EQ Cancel/Clear
MO/ST
Up
4
4
+
SPK Edit Test Tone
4
Melody
Sleep
2,3
Hi-Light Repeat
Score Fanfare