Table of Contents
Advertisement
Acknowledging special precautions and
Industry Canada Notice
Cautions
Any changes or modifications to your device not expressly approved in
this document could void your warranty for this equipment, and void
your authority to operate this equipment. Only use approved batteries,
antennas and chargers. The use of any unauthorized accessories may be
dangerous and void the device warranty if said accessories cause damage
or a defect to the device.
Although your device is quite sturdy, it is a complex piece of equipment
and can be broken. Avoid dropping, hitting, bending or sitting on it.
Information to user
This equipment has been tested and found to comply with the limits
of a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation; if this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient / relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rates (SAR) for wireless
mobile devices
The SAR is a value that corresponds to the relative amount of RF energy
absorbed in the head of a user of a wireless handset.
The SAR value of a device is the result of an extensive testing, measuring
and calculation process. It does not represent how much RF the device
emits. All mobile devices are tested at their highest value in strict
laboratory settings. But when in operation, the SAR of a device can be
substantially less than the level reported to the FCC. This is because of a
variety of factors including its proximity to a base station antenna, device
design and other factors. What is important to remember is that each
device meets strict federal guidelines. Variations in SARs do not represent
a variation in safety.
123
Safety precautions
Advertisement
Table of Contents
