Seat Kit
Groundsmaster
Model No. 31980—Serial No. 400000000 and Up
Model No. 31981—Serial No. 400000000 and Up
Model No. 31982—Serial No. 400000000 and Up
Installation
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Lower the cutting unit.
4.
Shut off the engine and remove the key.
5.
Disconnect the battery; refer to the electrical
system maintenance section of your Operator's
Manual.
2
Installing the Seat to the
Traction Unit
Parts needed for this procedure:
4
Bolt
8
Nut
1
Plate
1
Seat-switch wire harness
1
Air-ride-seat wire harness (Model No. 31982 only)
Positioning the Seat Assembly
1.
Remove the console from the seat base and
retain the nuts.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3200 or 3300 Series Traction Unit
Register at www.Toro.com.
Important:
Ensure that you support the
console after removing it so that it does not
crimp or hang by the cables and wires.
2.
Install the end of the seat-switch wire harness
labeled P2 (Seat Switch) to the seat-switch
connector under the seat.
3.
Align the seat studs with the holes in the seat
base
(Figure
1).
Figure 1
Model No. 31980 shown.
1. Seat
Original Instructions (EN)
All Rights Reserved *3434-642* A
Printed in the USA
Form No. 3434-642 Rev A
Installation Instructions
2. Seat base
g299316