Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ZERO-X TREXER ZX-RCP
Summary of Contents for ZERO-X TREXER ZX-RCP
-
Page 4: Table Of Contents
CONTENTS 1.0 WELCOME ....................4 2.0 IN THE BOX: ....................4 3.0 BATTERY SAFETY ..................5 4.0 RECHARGEABLE BATTERY CHARGING ............9 5.0 POWERING ON ..................10 6.0 R30 RECEIVER ................... 10 7.0 E45A BRUSHLESS ESC ................11 8.0 REMOTE CONTROL .................. 12 9.0 HEAD WHEEL INSTALLATION (OPTIONAL) .......... -
Page 6: Welcome
WELCOME Thank You for purchasing a Zero-X Remote Control Car. The Zero-X range has been specifically designed to provide the intermediate to advanced user with a great driving experience. Please take the time to read the following safety warnings and operating instructions carefully. -
Page 7: Battery Safety
IMPORTANT INFORMATION - PLEASE READ BEFORE USE When handled incorrectly, Lithium polymer batteries can be dangerous and can potentially harm persons and / or property. Zero-X does not accept any liability for damage to persons and/ or property, if the battery is not correctly charged, stored or protected. - Page 8 WARNING AND CAUTIONS 1. Detachable small parts should be stored safely and out of reach of children. 2. If interference is experienced, turn off the car and try it again at a different area. 3. The remote control will not function correctly if battery power is low. Please replace the batteries.
- Page 9 SAFETY PRECAUTIONS • The remote control car is not a toy. Please handle it appropriately. • The car requires a simple assembly before use. • Improper usage with alkaline cells or rechargeable batteries may damage the electronics of the car or the remote control. In order to operate the car safely, please observe the following points: •...
- Page 10 OPERATING THE CAR SAFELY Do NOT operate the car in the following places and situations. 1. On public roads or areas of high traffic. 2. In places that are crowded and where infants and children gather. 3. In residential areas and public parks. 4.
-
Page 11: Rechargeable Battery Charging
RECHARGEABLE BATTERY CHARGING Install the battery: 1. Turn the knob and open the battery holder as shown in Step 1. 2. Remove the rechargeable battery (11.1V 1050mAh 25C) and charge it using the supplied USB charging cable or the power adaptor as shown in Step 2 and Step 3. -
Page 12: Powering On
POWERING ON Please turn on the remote control first. Next, turn on the car. The LED indicator will blink in red. Please DO NOT touch the throttle knob and steering on the remote control. The LED indicator on the car will change to a constant red. Please assemble the top shell to the car. -
Page 13: R30 Receiver
R30 RECEIVER VCC/FAN VCC/FAN VCC/FAN VCC/FAN (VCC/FAN) Antena Please make sure that (CH2) is in a vertical position. VCC/FAN: Power Interface (VCC=5-6V) R30 Indicator Meaning Steering Constant red Matched with the remote servo control. (CH1) Searching for the remote control. Blinking red Please turn on the remote control and ensure it is within range. -
Page 14: E45A Brushless Esc
E45A BRUSHLESS ESC Please Do Not force or reverse insert all sockets. E45A Indicator Meaning Indicator Matched with the Constant red remote control. Power switch Power switch Blinking red rapidly Low Voltage VCC/BVD Heat sink Overheating Blinking red slowly Protection The motor is stuck Blinking red twice and stuck protection... - Page 15 1 ST TRIM (Steering servo trimmer) 2 TH TRIM (Throttle trimmer) If the car is not heading straight, it can be If the car cannot be stopped when the TH corrected via the ST TRIM. is at the middle position, use TH TRIM to adjust the stopping action.
-
Page 17: Rear Wing Installation
10.0 REAR WING INSTALLATION Install the rear wing with the two screws supplied. 11.0 REMOTE CONTROL BATTERY INSTALLATION Open the battery cover by removing the two screws with the supplied screwdriver. Then insert two AA-size batteries (not included) into the battery compartment and ensure that the polarity is correct. -
Page 18: Car Shell Assembly
12.0 CAR SHELL ASSEMBLY To assemble the car shell, align the holes on the car shell with the corresponding struts on the car chassis. There is one strut in front and two struts behind. Insert the 3 pins into the struts to secure the assembly. To disassemble, repeat the steps in reverse order. - Page 19 Zero-X and its subsidiaries and affiliates, relating to or arising out of your breach of any provision of these terms, your misuse of Zero-X products or its services, or your unauthorized modification or alteration of products or software.
- Page 20 Zero-X makes no warranty that the Zero-X product and services will meet your requirements or that use of the Zero-X services will be uninterrupted, timely, secure or error-free. Nor does Zero-X make any warranty as to the accuracy or reliability of any information obtained through Zero-X (including third party...
- Page 21 The preceding preclusion and limitation of liability will also not apply to claims for damages arising out of loss of life, bodily injury or health impacts for which Zero-X may be liable, or for non-contractual liability.
- Page 22 ANOTHER DIRECTED BRAND All Images, Information and Content are Copyright © 2023 Directed Electronics Australia Pty Ltd. All Rights Reserved. www.zero-x.com.au | www.zero-x.co.nz www.directed.com.au | www.directed.co.nz...