Hantech HNT-MH-41 Installation Manual

15-30°Universal PV Mounting System installation manual
Installation Steps：
1: Place the rubber pads under the front and rear leg
bases respectively, as shown in the following picture.
2: Install the L-shaped connector on the end of the
adjustable rear leg outer expansion pipe, as shown in
the following.
3: Install the adjustable front and rear legs on the
photovoltaic panel, as shown in the picture above.
4: Fix the assembled universal bracket on the wooden
floor or the metal sheet roof with tapping screw, as
shown in the above picture.
Note: Turn the screw here to
adjust the installation angle
according to the local
conditions.
5: You can also fix the assembled universal bracket
to the concrete floor or balcony wall with expansion
bolts (Note: you need to purchase them according
to the site conditions), as shown in the above.
Model: HNT-MH-41
No. Picture
01
02
03
04
05
Name QTY
Adjustable front leg 2
Adjustable rear leg 2
L-shaped connector 2
Rubber pad 4
Tapping screw 8
ST6.3*80
Hantech GmbH
Daimlerstr. 6
D-76185 Karlsruhe
www.hantech.eu