Table of Contents
Advertisement
2.2 Antennas
Connect cellular antenna to the router to main (ANT) SMA female connector.
Only run the router with a cellular antenna connected to the main antenna connector, as
the energy from the transmission is effectively reflected by the open end and can damage
the equipment.
Recommended tightening moment for screwing the antenna to the SMA female connectors is
0.9 Nm.
2.3 Ethernet Interfaces
The panel socket of RJ45 is used for Ethernet interface. The pinout of the socket is shown
in Figure
13
and described in Table 5.
Pin
Signal mark
1
Tx+
2
Tx-
3
Rx+
4
—
5
—
6
Rx-
7
—
8
—
Table 5: Ethernet Connector Pinout Description
The isolation barrier of the Ethernet ports against the ground is 1500 V.
Figure 13: Ethernet Connector Pinout
Description
Transmit Data+ (positive pole)
Transmit Data- (negative pole)
Receive Data+ (positive pole)
—
—
Receive Data- (negative pole)
—
—
16
ICR-2412
Advertisement
Table of Contents
