Trisa Sonicpower - Electric Toothbrush Manual

Device Overview

Key (Fig. A)

1. Replacement brush
2. On switch
3. Off switch
4. Power unit
5. Cover
6. Accu charger

Please note before using for the first time
Read through the instructions for use carefully. Keep these for referring to later or for handing on to someone who may use the device after you. The device may only be used for the purpose for which it was designed in accordance with these instructions. Please observe the safety instructions. The device is ready to operate only when the accu is charged.

Charging the Trisa Sonicpower

To charge the power unit open the cover (fig. B) and plug in the cable at the lower side (fig. C). The charging time is 24 hours. Make sure that the Trisa Sonicpower is not in contact with any liquid during charging. The device is operating only with cover on. Use the Trisa Sonicpower only with the cover on.

Run the accu down completely at least once every 6 months by using the device without recharging it. This measure will assure a long service life of the accu at maximum efficiency.

How to clean your teeth properly

The tapered filaments that are set into vibration by a newly developed sonic technology ensure an excellent and gentle cleaning. Moisten the filaments and apply a toothpaste of your choice. Use the toothbrush in the same way as it is recommended for manual toothbrushes by dentists. Brush at least two minutes each time.

Replacing the brush head

Replace the brush head regularly for reasons of hygiene - at the latest at the end of 3 months. Replacement sets are available from your dealer. For a simple exchange of the brush head please revert to fig. D.

Cleaning the device

To ensure that the device is hygienic and functions properly, the Trisa Sonicpower must be rinsed thoroughly under warm water after each use. Clean the detachable brush head thoroughly.

Manufacturer and service centre

Trisonic AG, Kantonsstrasse 31, CH-6234 Triengen, Switzerland