Honda ODYSSEY 2020 Owner's Manual page 153

uuLocking and Unlocking the DoorsuLocking/Unlocking the Doors from the Outside
To temporarily deactivate the function:
1. Set the power mode to OFF.
2. Open the driver's door.
3. Using the master door lock switch, operate
the lock as follows:
LockUnlockLockUnlock.
u The beeper sounds and the function is
deactivated.
To restore the function:
• Set the power mode to ON.
• Lock the vehicle without using the auto lock
function.
• With the smart entry remote on you, move
out of the auto lock function operation
range.
• Open any door.
1Locking the doors and tailgate (Walk away auto lock)
The auto lock function does not operate when any of
the following conditions are met.
•
The remote is inside the vehicle.
•
A door or the hood is not closed.
•
The power mode is set to any mode other than
OFF.
•
The remote is not located within a radius of about
5 feet (1.5 m) from the vehicle when you get out of
the vehicle and close the doors.
Auto lock function operation stop beeper
After the auto lock function has been activated, the
auto lock operation stop beeper sounds for
approximately two seconds in the following cases.
•
The remote is put inside the vehicle through a
window.
•
You are located too close to the vehicle.
•
The remote is put inside the tailgate.
If the warning beeper sounds, check that you are
carrying the remote. Then, open/close a door and
confirm the auto lock activation beeper sounds once.
Continued 151