Table of Contents
Advertisement
BLADE MAINTENANCE
WARNING! Before removing Top Hopper screw, ensure the machine is switched off,
and the machine is completely stopped.
WARNING! Take extreme care not to come in contact with cutting blades. Danger!
WARNING! If ejection chute becomes clogged or cutting blades become jammed,
under no circumstances should you place your hands in ejection chute to try to clear
obstruction, as this will lead to serious injury.
1. Switch the machine off, and make sure the machine is completely stopped.
2. Wear gloves when attempting any maintenance to the cutting blades.
3. Loose four safety 4 screws as shown on (Fig L), carefully lift up the hopper.
4. Steps on the hopper support with the foot, takes a tool to be fixed the blade of plate. (Fig
M)
5. Dismantles bit anchor screw (Fig N) with the suitable tool.
6. Close the hopper, tighten the screws.
NOTE: The blade is double edged. Should you have to change the blade, rotate the
blade 180 degree for sharper edge.
Fig L
Fig M
13 / 21
Advertisement
Table of Contents
