Advertisement
output 4 follow this principle.(It suggests to use the Out1 for the DVI display when output
channel have both DVI and HDMI display.)
6. To take the HDMI cable out and power off with the HDMI 1X4 extender, it can use as
normal mode.
Note: It can use HDMI-DVI cable for DVI Monitor. The step is same as above.
Out1- Out4: RJ45 output interface
In: HDMI input interface
DC 5V： 5V DC-DC Power Interface
To use four cat6/7 cables to connect the TX Out port with the CAT input port of the RX.
HDMI OUT: Receiver to connect the HDTV or other display.
DC 5V: 5V DC-DC Power Adaptor Interface.
Figure 1.1 rear panel showing picture
Figure 1.2 Front Panel Showing Picture
Figure 1.3 the rear and side board showing picture
Advertisement
