Advertisement
Quick Links
PROPER USE GUIDELINES
Cumulative Trauma Disorder can result from the prolonged use of manually powered hand tools. NorComp hand
tools are intended for the occasional use and low volume applications.
BLUE
RED
HAND TOOL
170-701-170-000
1. INTRODUCTION
NorComp 170-701-170-000 Hand Tool Assembly
consists of Die Assembly and Hand Tool Frame.
CAUTION
Read these instructions thoroughly
before crimping any contacts.
NorComp, Inc.
Charlotte, NC
CONTACT
SIZE RANGE
(AWG)
20-28
This document is subject to change
Rev 4
170-701-170-000
WIRE
INSULATION DIAMETER
MAXIMUM
0.040in [1.02mm]
Figure 1
2. DESCRIPTION
The tool features a tool frame with a stationary jaw
and handle, moving jaw, and moving handle. The
tool frame holds a die assembly with two crimping
chambers.
The die assembly features a wire anvil, insulation
anvil, wire crimper, and insulation crimper.
08/14/2023
Instruction Sheet
IS-170S
STRIP LENGTH
0.100in [2.54mm]
Page 1 of 3
Date Printed 8/14/2023
Advertisement
Summary of Contents for NorComp IS-170S
- Page 1 170-701-170-000 Instruction Sheet IS-170S PROPER USE GUIDELINES Cumulative Trauma Disorder can result from the prolonged use of manually powered hand tools. NorComp hand tools are intended for the occasional use and low volume applications. BLUE CONTACT WIRE HAND TOOL SIZE RANGE...
- Page 2 170-701-170-000 Instruction Sheet IS-170S 5. Holding the wire in place, squeeze the tool handles together until ratchet releases. Allow tool handles to open and remove crimped contact. 4. CRIMP PULL TEST 1. Refer Section CRIMPING PROCEDURE, crimp contact accordingly to achieve pull test in Figure 3.
- Page 3 170-701-170-000 Instruction Sheet IS-170S 2. The pivot pin and ratcheted pawl-bearing surface should be lubricated to ensure a smooth operation. DO NOT spray oil into tool to lubricate 3. When storing the tool, close the handles until the ratchet pawl is about to be released from the tooth of the ratchet.