Aqua Joe AJ-ET2Z - 2-Zone Electronic Water Timer Manual

Aqua Joe AJ-ET2Z - 2-Zone Electronic Water Timer Manual

Advertisement

Aqua Joe AJ-ET2Z - 2-Zone Electronic Water Timer Manual

Know Your Device

Read the owner's manual and safety rules carefully before operating your electronic water timer. Compare the illustration below to the actual unit in order to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
Know Your Device

  1. Zone A Timer
  2. Digital Screen
  3. Watering Frequency
  4. Battery Capacity
  5. Current Time
  6. Zone B Timer
  7. Frequency Button
  8. Current Time Setting
  9. Cover

Technical Data

Power 2 AA Alkaline batteries (not included)
Operating Pressure 10 - 100 PSI
Max Pressure 120 PSI
Rated Flow 9.24 GPM
Water Outlet/Inlet Thread Size 0.75 in. (1.9 cm)
Watering Cycles 1-13 cycles
Cycle Time Max 60 min each
Watering Frequency 12 hrs up to every 7 days
Valves/Number of Zones 2
Weight 0.9 lbs (0.4 kg)

Battery Installation

  1. Open the battery compartment on the lower back of the timer.
  2. Pull out the battery compartment and insert two AA batteries (not included). Secure the battery compartment back into the unit.
    Battery Installation

Set Current Time

Refer to Fig. 2 for the following instructions.

  1. Use the "+" button to increase time displayed.
  2. Use the "-" button to decrease time displayed.
  3. Make sure that correct AM/PM is displayed.
    Setting the Current Time

TIP: Holding "+" or "-" button down allows you to scroll or more quickly through your time selection.

Programming the Unit

  1. To set watering frequency, press the " " button to cycle through options. Settings range from 1st to 7th. You may set up 1st (once a day), 2nd (once every two days), 3rd (once every three days), etc (Fig. 3).
    Programming the Unit
  2. To select water cycle on dial, turn the dial to select one of the 13 settings you wish to run. For example, water at 6 AM for 15, 30 or 60 minutes; water at 6 AM and 6 PM for 15, 30 or 60 minutes; water at 7 AM for 15, 30 or 60 minutes; and water at 7 AM and 7 PM for 15, 30 or 60 minutes (Fig. 3).

Installing the Device

Attach timer securely to the faucet and hose. Open the faucet and leave it open. Water will turn on and shut off at the selected time. Ensure cover is closed securely.

Manual Operation

Manual Operation
To water for non-timed application, with the water turned on at the faucet, turn the dial to ON. Turn the dial to OFF to stop manual watering.

Maintenance and Care

Follow the steps below if the timer stops working or exhibits poor water quality due to debris or dirt build-up.

  1. Remove the inlet filter from the faucet connection and rinse under water to remove any dirt or debris.
    Maintenance - Step 1 - Remove inlet filter
  2. With timer compartment cover closed securely, flush faucet connection with a stream of water, and repeat for both hose connections.
    Maintenance - Step 2
  3. Replace inlet filter before reattaching to water source. Tighten faucet connection securely.


Detach from faucet during freezing weather. This product is intended for outdoor watering use only. Do not use water exceeding 100 ̊ F (38 ̊ C ) or with pressures exceeding 100 psi.

Service and Support

If your AQUA JOE AJ-ET2Z 2-Zone Electronic Water Timer requires service or maintenance, please call the Snow Joe + Sun Joe customer service center at 1-866-SNOWJOE (1-866-766-9563).
Service and Support - Recording the model numbers

© 2019 by Snow Joe, LLC | All rights reserved. Original instructions. SAVE THESE INSTRUCTIONS

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Aqua Joe AJ-ET2Z - 2-Zone Electronic Water Timer Manual

Advertisement

Need help?

Need help?

Do you have a question about the AJ-ET2Z and is the answer not in the manual?

Questions and answers

Table of Contents