Table of Contents
Advertisement
I
NSTALLATION
Connecting VHF and UHF
Antennas, continued
If you use a different 300-ohm
antenna with twin flat leads, fol-
low the directions below, but skip
step 1.
1
Push the stem of the rod
antenna into the antenna
mount.
2
Connect both antenna leads
to a combiner.
14
C
T
: I
HAPTER
WO
NSTALLATION
3
Plug the combiner into the
terminal on the rear panel of
the TV/VCR.
Connecting Cable TV
Systems to the TV/VCR
Choose one of the sections below
for connecting a cable system.
This TV/VCR is cable-ready; you
don't need a converter for basic
cable channels.
Cable Without a
Converter Box
To connect cable without a
converter box:
1
Plug the incoming cable into
the terminal on the rear
panel of the TV/VCR.
Cable With a
Converter Box
If your cable company
scrambles some channels and
requires you to use a converter
box for only those channels, use
these instructions.
You will need the following
pieces of equipment, which you
can purchase from an
electronics store:
• A two-way splitter
• An RF (A/B) switch
• Four lengths of coaxial cable
1
Plug the incoming cable into
the 2-way splitter.
Advertisement
Table of Contents
