Beko WCV 7612 XS0 User Manual page 18

C
INFORMATION
• If the machine does not pass to the
spinning step, Rinse Hold function might
be active or the automatic unbalanced
load detection system might be activated
due to the unbalanced distribution
of the laundry in the machine.
4.3.14 Loading door lock
There is a locking system on the loading door
of the machine that prevents opening of the
loading door in cases when the water level is
unsuitable.
Loading door light will start flashing when the
machine is switched to Pause mode. Machine
checks the level of the water inside. If the
level is suitable, Loading Door light illuminates
steadily within 1-2 minutes and the loading
door can be opened.
If the level is unsuitable, Loading Door light
turns off and the loading door cannot be
opened. If you are obliged to open the Loading
Door while the Loading Door light is off, you
must cancel the current programme. See.
"Cancelling the programme"
4.3.15 Changing the selections
after programme has started
Switching the machine to pause mode
Press the Start / Pause button to switch the
machine to pause mode while a programme
is running. The light of the step which the
machine is in starts flashing in the Programme
Follow-up indicator to show that the machine
has been switched to the pause mode.
Also, when the loading door is ready to be
opened, Loading Door light will also illuminate
continuously in addition to the programme step light.
Changing the auxiliary function, speed and
temperature
Depending on the step the programme has
reached, you can cancel or select the auxiliary
functions. See, "Auxiliary function selection".
You can also change the speed and
temperature settings. See, "Spin speed
selection" and "Temperature selection".
C
INFORMATION
• If no change is allowed, the
relevant light will flash 3 times.
18 / EN
Adding or taking out laundry
1. Press Start / Pause button to switch the
machine to pause mode. The programme
follow-up light of the relevant step during
which the machine was switched into the
pause mode will flash.
2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out
the laundry.
4. Close the Loading Door.
5. Make changes in auxiliary functions,
temperature and speed settings if necessary.
6. Press Start / Pause button to start the machine.
4.3.16 Cancelling the programme
To cancel the programme, turn the Programme
Selection knob to select another programme.
Previous programme will be cancelled. End /
Cancel light will flash continuously to notify that
the programme has been canceled.
Your machine will end the programme when you
turn the Programme Selection knob; however,
it does not drain the water inside. When you
select and start a new programme, the newly
selected programme will start depending on the
step the previous programme was canceled in.
For example, it may take in additional water or
continue to wash with the water inside.
C
INFORMATION
• Depending on the step where the
programme was canceled in, you may have
to put detergent and softener again for
the programme you have selected anew.
4.3.17 End of programme
"End" appears on the display at the end of the
programme.
1. Wait until the loading door light illuminates
steadily.
2. Press On / Off button to switch off the
machine.
3. Take out your laundry and close the loading
door. Your machine is ready for the next
washing cycle.
Washing Machine / User's Manual