Storing The Channels Automatically; Selecting A Channel Numbered Ten Or Over - Samsung CB21K22 Owner's Instructions Manual

ENG
Mode
Adjust
Size
Select Enter
Auto Store
Manual Store
Add/Erase
Fine Tune
Sort
Select Enter
P 1
471 MHz
Exit
Sort
From
To
Store
Select Adjust

Selecting a Channel Numbered Ten or Over

Storing the Channels Automatically

Picture
Custom
: Normal
Exit
Channel
Exit
48 %
Channel
: P 1
: P--
: ?
Exit
12
You can scan the frequency ranges available on your television and
in your country and store all the channels found automatically.
The channels are stored in the order in which they appear in the
frequency bands. It is possible that the automatically allocated
numbers may not correspond to those by which you wish to
identify the channels. If this is the case, refer to "Sorting the Stored
Channels" on page 16.
1
Press the MENU button.
Press the L or M button to select the "Channel".
2
3 + –
Press the or button to select the "Auto Store".
4 + –
Press the or button again.
Result: The horizontal bar is displayed, and then channels are
stored in an order which reflects their positions in the
frequency range. Finally, the search will end automatically.
5
When searching and storing is complete, the "Sort" menu is
displayed.
To...
Sort the stored channels
into the desired numerical order
Exit the channel store function
without sorting the channels
➣
If sound does not work regularly after storing channels, select
the sound system which best corresponds in "Manual Store"
menu (refer to the opposite page).
When using the numeric buttons to select a channel stored at
programme position ten or higher, follow the instructions below.
1
Press the -/-- button.
Result: The "--" symbol is displayed.
2
Enter the two-digit channel number.
Example: To select channel 42, press 4, followed by 2.
Then...
Go to Step 4 of the "Sorting
the Stored Channels"
procedure on page 16.
Press the MENU button
repeatedly until the menus
disappear.