NuVision TPEN-H1BK - Digital Pen Manual

INTRODUCTION

This NuVision Digital Pen works with any device using Windows INK with MPP protocol.

PACKAGE CONTENTS:

• Digital Pen
• (1) AAAA Battery
• (2) Soft Tips
• (2) Hard Tips
• Tip Replacement Tool

NOTE: One of the Tips is installed in the Digital Pen.

INSTALL THE BATTERY

1. Unscrew the top of the pen by turning it counter-clockwise.
2. Insert one battery, positive (+) side down, into the battery compartment.
3. Replace the pen top by screwing back on, clockwise.

USING THE DIGITAL PEN

To 'awaken' the pen from sleep mode, press either Eraser or Alt buttons. Your pen will be active and ready to use.

PARTS OF THE PEN

RECOMMENDED: Keep the unused tips in the foam portion of the package.

REPLACING THE TIP

The NuVision Digital Pen comes with 2 types of Tips, Soft and Hard. They can be removed and replaced by using the included

Tip Replacement Tool as follows:

1. With the Tip Replacement Tool in one hand, and the Pen in another, bring the Tool over the tip of the Pen.
2. Pinch the tool closed around the Tip, and slowly pull the Tip out of the body of the Pen.
3. To place a new tip, use the Tip Replacement Tool to remove a tip from the packaging. With the pointed end of the Tip pinched in the Tool, slide the new Tip into the Pen until the neck of the Tip is not visible.

Choking Hazard
This device may contain small parts which may be a choking hazard to children under 3. Keep small parts away from children.

Contact NuVision Technical Support
Email: cs@nuvision.com
Phone: (800) 890-1288
Hours: 8:30am to 5:30pm PST M-F

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download NuVision TPEN-H1BK - Digital Pen Manual