Samsung PPM42H3 Owner's Instructions Manual page 11

Installing the Display on the Wall Attachment Panel
The exterior of the PDP may be different than the picture.
(Assembly and installation of the plastic hanger is the same.)
1
Remove the screws from the back of the PDP.
2
Use the screws and assemble the plastic hanger.
Please ask the installers to install the wall mount bracket.
Please be sure to check if the plastic hanger is completely secured on both the left and right
side after hanging the PDP on the wall mount bracket.
Please avoid catching your fingers while installing and adjusting the angle.
Please tightly secure the wall mount bracket to the wall to avoid injury from a falling PDP.
3
Tighten the screws of the plastic hanger to the back side of the PDP.
4
Put the 4 pegs on the PDP in the grooves of the wall mount bracket and pull down on the PDP (!) to
secure it to the wall mount bracket (@). Tighten the screws as shown (#) so that the PDP cannot be
separated from wall mount bracket.
PDP panel
Wall
Wall attachment panel bracket
11
ENG