Table of Contents
Advertisement
FAILURE TO INSTALL AND MAINTAIN A NEW, LISTED
TEMPERATURE AND PRESSURE RELIEF VALVE WILL
RELEASE THE MANUFACTURER FROM ANY CLAIM
WHICH MIGHT RESULT FROM EXCESSIVE
TEMPERATURE AND PRESSURES.
Keep clear of the temperature and pressure relief valve discharge
line outlet. The discharge may be hot enough to cause scald injury.
The water is under pressure and may splash.
This Stainless Steel tank requires a premium grade of thread
sealant, Loctite 565, to ensure leaks do not occur from the tank
fittings after installation.
INSTALL TEMPERATURE AND PRESSURE RELIEF
VALVE (if not factory installed)
Temperature and pressure relief valve discharge piping must be piped
near the floor to eliminate potential of severe burns. Do not pipe in
any area where freezing could occur. Do not install any shut-off
valves, plugs or caps to the temperature and pressure relief valve or
piping.
INSTRUCTIONS FOR POTABLE CONNECTIONS
1. BEFORE PROCEEDING WITH THE INSTALLATION,
CLOSE THE MAIN WATER SUPPLY VALVE. After
shutting off the main water supply, open a faucet to relieve
the water line pressure to prevent any water from leaking
out of the pipes while making the water connections to the
water heater. After the pressure has been relieved, close the
faucet. The DRAIN/COLD water inlet and HOT water
SECTION V
WATER CONNECTIONS
WARNING
CAUTION
WARNING
19
Advertisement
Table of Contents
