Advertisement
4.
Mount SPARSH VP310 on the Desk
Ÿ You can attach the Foot Stand in the following ways - at an angle of 35
degrees and 50 degrees.
5.
Step 2
CONNECT
Connect the Handset
Ÿ Connect the handset of the EON310 to the phone body using the Spring
Cord (supplied with the phone).
Ÿ Connect the long straightened end of the Spring Cord into the RJ9
connector on the left side panel of the phone, marked with the symbol .
Connect the Headset (not supplied by Matrix)
If you want to use a Headset,
Ÿ Plug any standard stereo headset with 3.5mm single connector into the
headset jack on the left side panel of the phone, marked with the symbol .
Stand attached at
35 degree angle
Ÿ You may also plug in a headset with RJ9 connector into the headset port on
the left side panel of the phone, marked with the symbol
Stand attached at
50 degree angle
Router /
LAN Switch
Connect a PC to the Phone
Ÿ Plug in the Ethernet Cable into the PC Port of the phone and the other end into
the LAN Port of your PC.
Headset
Handset
Headset
.
LAN
PC
5VDC--2A
Computer
Adapter
6.
Connect the IP Network
Ÿ Connect the LAN Port of the phone to the IP Network — A Router or LAN
Switch — using the Ethernet Cable.
Connect the Power Supply
Ÿ Plug in the connector of the Adapter provided with the phone into the power
jack (DC Jack) with the label 5VDC-2A at the bottom of the phone.
Plug in the Power Adapter into a power outlet.
Ÿ
Ÿ PoE enabled phone can be powered over Ethernet by connecting it to a PoE
enabled LAN Switch (IEEE 802.3af Compliant). In this case you need not
connect the Power Adapter.
Note: If both the power options, that is, PoE as well as Power Adapter are
available to the phone, then the phone will derive power from the PoE
enabled LAN Switch.
Step 3
STARTUP AND OPERATE
Ÿ When the IP Phone is connected to the network and supplied with power, the
booting process initiates.
Ÿ After loading the application, the phone obtains the Network Settings,
updates the Firmware (if required), obtains the Configuration and then
attempts to register.
To configure and register the phone as a SIP Extension, refer to the
Ÿ
System Manual. For operating instructions refer to the
EON48_310_SPARSH VP248_310_User Guide.
The documentation can be
found at http://www.matrixtelesol.com/technical-document.html
MATRIX COMSEC
Head Office
394-GIDC, Makarpura, Vadodara - 390010, India
Ph:+91 265 2630555
E-mail: Support@MatrixComSec.com
www.MatrixTeleSol.com
Advertisement
