LockTech LTKSD 2.0 Set Up And Operating Instructions

1) Charge the LTKSD2 using the provided USB charging cable and a standard 5v power supply. Do not use a computer for charging,
this will cause the camera to go into PC mode. The red lightning bolt light on end of tool will illuminate when charging. When the
LTKSD2 is fully charged the red lightning bolt charging light will change from red to green.
2) Download and install the "Max-VIEW" app to your Android or IOS smart phone.
3) Turn on the LTKSD2 by holding the power button down for 2-3 seconds, the blue WiFi symbol light should turn on and start
blinking. This indicates the LTKSD2 is looking for a wifi connection with your phone.
4) Open the Max-View app and click on "connected devices" then "begin to connect" button to launch wifi connections.
5) Find and connect to the "MaxView-####" network. The first time connecting to the network connection you may get a message
that states, "internet not available" this is normal and click "Always Connect."
6) After your phone has connected to the "MaxView-####" wifi connection return to the Max-View app on your phone. Then click the
"blue circle with arrow" to display the LTKSD2 video. At top left click on "Landscape Mode" to orient screen correctly.
7) The camera image should now be displayed on the screen.
On Windows computers, it is recommended to use the Windows "Camera" program.
a) Connect the LTKSD2 to the computer via USB cable.
b) Open the default Windows Camera program and press the power button on the LTKSD2.
c) If the LTKSD2 image is not being displayed, press the "change camera" button in the upper right corner of the screen, to
switch to the LTKSD2.
On Mac computers, it is recommended to use the Apple "Photo Booth" App.
a) Connect the LTKSD2 to the computer via USB cable.
b) Click on LaunchPad Button and open the Photo Booth App.
c) Press the power button on the LTKSD2.
d) The LTKSD2 image should now be displayed on the screen.
The lock can be read from 1 to 5 or 5 to 1. The following directions are for starting with 5.
1) Carefully insert the LTKSD2 with no spacers into a Kwikset Smartkey lock fully until it stops. The #5 space wafer should now be
displayed on the screen. Using the provided "Wafer Depth Chart" identify the image on the chart that is the same as the image
being displayed on the screen for space #5.
2) Use the Light Dimmer Button (next to the power button) on the LTKSD to intensify or dim the light as needed.
3) Write down the correct depth for position #5. Alternatively, you can click the "Camera" icon to take a picture of each position or
click the "Video" icon and slowly withdraw the key out of the lock to record all 5 positions.
4) After the #5 space is recorded, gently remove the LTKSD2 from the lock. Gently slide the #4 spacer (for the correct orientation see
the diagram on the depth gauge chart) over the key blade until it stops at the shoulder of the LTKSD2 key. IMPORTANT: Do not
force the spacers on to the LTKSD2 key. The correct orientation is if the LTKSD2 key blade is pointing away from you, the spacer #
on the spacers should be facing the user and on the right side of the key blade when the LTKSD2 is being held horizontally with the
tether cord going through the spacer as shown in the diagram on the Depth Chart
5) Again, using the provided "Wafer Depth Chart" identify the image on the chart that is the same as the image being displayed on
the screen for space #4. Record the depth for space #4.
LTKSD 2.0
LockTech Kwikset Smartkey Decoder
Setup and Operating Instructions
WIFI SETUP
USB SETUP
INSTRUCTIONS