Continuity Measurement; Diode Measurement - East Tester ET1260 User Manual

Users manual
3. Re-connect the probe end of positive lead to test circuit, and measure capacitance value.

2.1.9 Continuity measurement

Basic information
Test power source: 1mA.

Beeper threshold: 1Ω-1000Ω is available, and 10Ω as a default.

Operation description
1) Press to select continuity measurement function.
Description: When the measured resistance value is larger than the beeper threshold, display
OPEN, and when the measured resistance value is smaller than the beeper threshold, display
resistance value.
2) Connect test lines as indicated in the chapter of "1.4 Measurement wiring".
3) Press the softkey of Setup (
lower than beeper threshold, the beeper beeps, and the beeper threshold can be set as 1Ω-1000Ω,
with 10Ω being a default.

2.1.10 Diode measurement

Basic information
Test current source: 1mA.

Beeper threshold: 0.3V≦test voltage≦3V, non-adjustable.

Operation description
1. Press to select diode measurement function.
Description: When voltage value is higher than measurement threshold, display OPEN,
otherwise display voltage value.
2. Connect test lines as indicated in the chapter of 1.4 Measurement wiring.
ET1260B and ET1260A
) to set beeper threshold: when the measured resistance is
6 1/2 Digit Multimeter
23