Advertisement
Advertisement
Related Manuals for Lydsto P1 MINI
Summary of Contents for Lydsto P1 MINI
- Page 1 Lydsto Robotic Pool Cleaner P� MINI Manuel...
-
Page 3: Table Of Contents
Reminder Before using this product, please read this manual carefully and keep it properly. Table of Contents Warning � � Product introduction Parameter � Notes required before use � Instructions for use � Product cleaning � �... -
Page 4: Warning
Warning �. Read the manual carefully and use the cleaning robot according to the manual. We shall not be liable for any loss or injury caused by improper use. �. Use only the accessories recommended or sold by the manufacturer. �. -
Page 5: Product Introduction
Product introduction The eco-friendly robotic pool cleaner is a new type of rechargeable self-cleaning robot that filters pool water to clean the pool. Handle Float Top cap Catch hook Scree Cleaning scraper Chassis Adapter �... -
Page 6: Parameter
Parameter Main engine Product name Robotic Pool Cleaner P� MINI Product model YM-P�MINI-��、YM-P�MINI-�� ��W Rated power Charger input ���-���V~ ��/��Hz Charger output ��.�V �A Battery capacity ����mAh ≤�H Charging time Water filtration ����GPH Filtration capacity ���μm Velocity of movement ��.�ft/min（��Meters / min） IPX�... -
Page 7: Notes Required Before Use
Notes required before use �. Place the bottom of the cleaner toward the pool to avoid scratches. �. Install a float and tighten set screws before use. �. Install cleaning scraper to improve cleaning effect. �. Make sure that the top cover and chassis of the cleaning robot are properly assembled and fastened. - Page 8 Notes required before use �. When fixing the top cap and chassis, pay more attention to the installation direction, as shown in the following figure: The plug pin indicated by the arrow should be aligned with the position of the hole near the chassis buckle.
-
Page 9: Instructions For Use
Notes required before use �. After use, turn off the cleaning robot �. Do not touch the wall when robotic pool cleaner entering or taking out the swimming pool, so as not to scratch the wall or damage the robotic pool cleaner. �. -
Page 10: Product Cleaning
Product cleaning �. Open the cleaner through the buckle. �. Remove the filter. �... - Page 11 Product cleaning �. Clean the filter and chassis. �. Reassemble the cleaning robot. �...
-
Page 12: Faq
�. Everything is normal during operation, but the robot will get stuck on the drain pipe or dry cover: (�) Please remove the cleaning scraper for the water inlet. �. The robot beeps and cannot operate after entering the water: (�) Check the state of the charging indicator light;... - Page 13 �. If the robot stops or gets stuck: The product itself does not have the ability to overcome obstacles. You can preform the following operations: (�) When stopping, check whether the cleaning scraper is stuck; (�) Check whether the bottom of the pool is uneven; (�) Check whether there are other objects stuck at the bottom of the machine.
- Page 14 The device has been evaluated to meet general RF exposure requirement. The device can be used in fixed/mobile （ min��cm） exposure condition without restriction. Manufacturer: Hubei Yimu Electronic Technology Co., Ltd. Address: �-��-��� Modern Sino-Canada Science and Technology City, West of Telephone: +�� ���-���-���� Yewang Road, Shazui Street, Xiantao,HubeiProvince,China Website: https://www.lydsto.com/ ��...
Need help?
Do you have a question about the P1 MINI and is the answer not in the manual?
Questions and answers
Does mini cleaner have different speeds?
No, the Lydsto P1 MINI cleaner operates at a fixed cleaning speed of 52.5 ft/min. There is no mention of multiple speed settings.
This answer is automatically generated
Where is the battery in a P1 mini pro
Where is the battery
Does the mini have different speeds?
Does this mini cleaner have different speeds?
can you change the wheels around so it covers more of the pool. I have 18 foot round above ground pool