Warning; Detailed Safety Instructions - METASONIX RK8 Filterwall Owner's Manual

WARNING:

this is an extremely abnormal product. If you purchased it
expecting to get "moogy" or "conventional" filter sounds, you
will be sorely disappointed.
CAUTION: to reduce the risk of electrical shock, do not disassemble.
DANGER! DANGER! HIGH VOLTAGE INSIDE. There is a 48v dc supply
internally. No user serviceable parts inside. Refer servicing to qualified
service personnel.

DETAILED SAFETY INSTRUCTIONS:

All the safety and operation instructions must be read before the RK8 is operated. If you don't read and HEED
them, you are a MORON and you deserve to be raped by a 400-pound brony.
RETAIN INSTRUCTIONS: The safety and operating instructions should be retained for future reference.
HEED WARNINGS: All warnings on the RK8 and in the operating instructions should be adhered to.
FOLLOW INSTRUCTIONS: All operating instructions should be followed.
WATER AND MOISTURE: The RK8 should not be used near water (e.g. near a bathtub, washbowl, kitchen sink,
laundry tub, in a wet basement, near a swimming pool etc., ya stupid bastard). Care should be taken so that
liquids are not spilled onto or near the enclosure.
VENTILATION AND COOLING: The RK8 normally operates VERY warm to the touch. It MUST be situated so that
its location or position does not interfere with convective cooling.
The RK8 MUST NOT be used on a bed, sofa rug or similar surface which may prevent proper cooling. It is NOT a
toy, AND IT IS NOT A DILDO. If the RK8 is mounted in a rack or other built-in installation, space must be left
around it to allow convection from the case.
HEAT: The RK8 MUST be situated away from heat sources such as
radiators, heat registers, stoves, or other devices (including power
amps) that produce heat. We DO NOT recommend leaving the RK8
powered up for long periods.
POWER SOURCE: The RK8 should be connected to a Eurorack power supply of adequate capacity. It uses about
1400 mA on power-up and 600 mA after warming up fully from the +12v line. DO NOT attempt to use low cost
power supplies.
POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or
pinched by items placed upon or against them.
CLEANING: The RK8 should only be cleaned with a soft cloth moistened with water. Unplug the power supply
before attempting to clean.
NON-USE PERIODS: The power supply of the RK8 should be unplugged from the outlet when left unused for a
long period of time.
DAMAGE OR TUBE REPLACEMENT REQUIRING SERVICE: