Page 1
Access Control Panels Quick Reference Guide and Wiring Diagrams www.BadgePass.com...
Page 2
All DIP switches should be set to the OFF position for normal operation. Make sure to remove the plastic between the battery and the connector. To set the address on the BP 1501: • Open a browser window and go to http://192.168.0.251...
Page 3
• Click on Apply settings in the left menu then click on the ‘APPLY SETTINGS AND REBOOT’ button. The panel will reset.
Page 4
BP 1502 Quick Reference Guide All DIP switches should be set to the OFF position. Make sure to remove the plastic between the battery and the connector.
Page 5
To set the address on the BP 1502: • Open a browser window and go to http://192.168.0.251 (this is the default factory address for the panel). • Click “Login” The user name is admin and the password is password. (This can be changed once you log in).
Page 6
BP 2500 Quick Reference Guide All DIP switches should be set to the OFF position for normal operation. Make sure to remove the plastic between the battery and the connector. To set the address on the BP 2500: • Open a browser window and go to panel).
Page 7
• Click “Login” The user name is admin and the password is password. (This can be changed once you log in). • Click on Network from the menu on the left. o Set your IP address and other network information then click ‘ACCEPT’. •...
Page 8
BP 52 Quick Reference Guide Make sure that only one BP 52 (If there is more than one hooked to a controller) has the RS 485 terminator (J5) jumper in place.
Page 9
BP 51e Quick Reference Guide All DIP switches should be set to off for normal operation.