Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
REGULATORY STATEMENTS FCC Certification The United States Federal Communication Commission (FCC) and the Canadian Department of Communications have established certain rules governing the use of electronic equipment. Part15, Class B This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference...
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. 1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2.
Page 5
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B conforme á la norme NMB-003 du Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
INTRODUCTION The 802.11b/g/n PCI-E Half Mini Card is a device that allows you connect your computer to a wireless local area network (LAN). A wireless LAN allows your system to use wireless Radio Frequency (RF) technology to transmit and receive data without physically attaching to the network.
SOFTWARE INSTALLATION Install the device 1. Make sure the computer is turned off. Remove the expansion slot cover from the computer. 2. Carefully slide the 802.11b/g/n PCI-E Half Mini Card into the PCI-E slot. Push evenly and slowly and ensure it is properly seated. 3.
Page 8
2. Select the language then click “Next” to continue. 3. Click the “Next” to continue Ben J. Chen Page 7 3/4/2010 ...
Page 9
4. Click the “Install” to continue 5. When the following screen appears, click “Finish” then restart computer to complete the software installation. Ben J. Chen Page 8 3/4/2010 ...
To verify if the device exists in your computer and is enabled, go to Start -> Control Panel -> System -> Hardware -> Device Manager. Expand the Network Adapters category. If the Realtek RTL8191SE Wireless LAN 802.11n PCI-E NIC is listed here, it means that your device is properly installed and enabled.
NETWORK CONNECTION Once the device driver is well installed, a network setting described in the following should be also established. 1. Click the Wireless icon to enable Windows Zero Configure. 2. Select the AP then click the Connect ...
Page 12
3. Surfing the Internet after completing connection. Ben J. Chen Page 11 3/4/2010 ...
Need help?
Do you have a question about the Realtek RTL8191SE and is the answer not in the manual?
Questions and answers