Table of Contents
Advertisement
Operations
Control panel
01 Cycle Selector
02 Display
03 Temp.
04 Rinse
05 Spin
06 Options
07 Delay End
WW90M64FOPW_DC68-03863B-01_EN.indd 33
02
07
Turn the dial to select a cycle.
The display shows current cycle information and estimated time
remaining, or an information code when a problem occurs.
For buttons and icons, refer to the corresponding page.
Press to change the water temperature for the current cycle.
Press to change the rinse count for the current cycle. You can set the
rinse count to a max of 5, depending on the cycle.
Press to change the spinning speed for the current cycle. The
revolutions per minute (RPM) differs with the model.
• Rinse Hold(No indicator): The final rinse process is suspended so
that the laundry remains in the water. To unload the laundry, run
a drain or spin process.
- To use the Rinse Hold option, press Spin repeatedly until all
rpm numeric indicators turn off. Not available for the DRAIN/
SPIN cycle.
• Spin Only: To run the Spin Only cycle, press Spin for 3 seconds.
When the cycle time and spinning speed appear, press Spin
repeatedly until a desired spinning speed is selected. Then,
press and hold Start/Pause (Hold to Start) to start the cycle. The
spinning time depends on the selected cycle.
Press to select the options. Availability of the options depends on
the cycle.
Delay End lets you set the end time of the current cycle. Based
on your settings, the start time of the cycle will be determined
by the machine's internal logic. For example, this setting is useful
for programming your machine to finish a wash at the time you
normally return home from work.
• Press to choose a preset unit of hours.
08
09
10
03
04
05
06
11
12
English 33
2018/3/17 13:42:53
Advertisement
Table of Contents
