Honda HR-V 2024 Owner's Manual page 102

Indicator Name
Safety Support
Indicator (Amber)
* Not available on all models
On/Blinking
● Comes on if there is a problem with Road
Departure Mitigation system, CMBS
Speed Braking Control * , or blind spot
information system * .
Models with Parking Sensor System
Comes on if there is a problem with the
●
parking sensor.
Indicator may come on temporarily when the
●
Maximum Load Limit is exceeded.
Comes on if the Road Departure Mitigation
●
system, Low Speed Braking Control
CMBS TM are deactivated temporarily after
the battery has been disconnected and then
reconnected.
● Stays on constantly - Have your vehicle checked
TM , Low by a dealer.
Check if the area around the sensor(s) is covered
●
with mud, ice, snow, etc. If the indicator stays on
even after you clean the area, have the system
checked by a dealer.
Make sure the total load is within the Maximum
●
Load Limit.
2 Maximum Load Limit P. 403
Stays on constantly - Have your vehicle checked
●
by a dealer.
Drive a short distance at more than 12 mph (20
●
* and km/h). The indicator should go off. If it does not,
have your vehicle checked by a dealer.
uuIndicatorsu
Explanation
Continued
101