ITC VersiControl 2251A-01 Series Installation Instructions

Addressable VersiControl
Smart System
Part#: 2251A-KKKK-YY-01
PARTS / TOOLS NEEDED:
VersiControl RGB
Smart System
Safety Instructions
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Do not install any luminaire assembly closer than 6" from any combustible materials.
• Positive (+) inputs require a fuse if the attached wire leads are not rated to handle the max current.
• This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interferences received, including interference that may cause undesired operation
1.
INSTALL: Determine the installation location for your control module. Make sure to consider the size of the module (7.5"L x 5"W x
1.5"H) when determining your location. Note, it will require room for access and for wiring. Screw the controller in place using four M5
stainless steel screws (not provided) sized appropriately for the substrate material used. Make sure when mounted, that the Blue-
tooth antenna is not obstructed by metal objects.
7.5"
2.
CONNECT CONTROL PAD: If using the control pad (optional), insert the connector on the control pad into the connector on the
module. Refer to control pad installation instructions for more detailed information.
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
RGB Lighting Mounting Screws x 4
(Varies)
Bluetooth Antenna
INSTALLATION INSTRUCTIONS
(not provided)
5"
For warranty information please visit www.itc-us.com/warranty-return-policy
Butt Splices
(not provided)
DOC #: 710-00213 • Rev A • 04/25/22
Power Drill
1.5"
Page 1 of 4