Advertisement
KNX A2-B2
Door Operator Control Module
Technical specifications and installation instructions
EN
Elsner Elektronik GmbH Control and Automation Engineering
Herdweg 7
D – 75391 Gechingen Phone +49 (0) 70 56 / 93 97-0
Germany
Fax
+49 (0) 70 56 / 93 97-20 www.elsner-elektronik.de
info@elsner-elektronik.de
Advertisement
Table of Contents
Summary of Contents for elsner elektronik KNX A2
- Page 1 KNX A2-B2 Door Operator Control Module Technical specifications and installation instructions Elsner Elektronik GmbH Control and Automation Engineering Herdweg 7 D – 75391 Gechingen Phone +49 (0) 70 56 / 93 97-0 info@elsner-elektronik.de Germany +49 (0) 70 56 / 93 97-20 www.elsner-elektronik.de...
- Page 2 Transient emissions: • EN 60730-1:2000 Section EMC (23, 26, H23, H26) (threshold category: B) • EN 50090-2-2:1996-11 + A1:2002-01 (threshold category: B) Door operator control module KNX A2-B2 • Version: 24.04.2013 • Technical changes and errors reserved.
- Page 3 Elsner Elektronik is not liable for any changes in norms and standards which may occur after publication of these operating instructions. Door operator control module KNX A2-B2 • Version: 24.04.2013 • Technical changes and errors reserved.
- Page 4 After the bus voltage has been applied, the device will enter an initialisation phase last- ing a few seconds. During this phase no information can be received via the bus. Door operator control module KNX A2-B2 • Version: 24.04.2013 • Technical changes and errors reserved.
Need help?
Do you have a question about the KNX A2 and is the answer not in the manual?
Questions and answers