BenQ W1800 User Manual page 21

5. Switch all of the connected equipment on.
The projector will search for input signals. The current input signal being scanned appears. If the
projector does not detect a valid signal, the message "No Signal" will continue displaying until an input
signal is found.
You can also press
26.
• Please use the original accessories (e.g. power cord) to avoid possible dangers such as electric shock and fire.
• If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds before
energizing the lamp.
• The Setup Wizard screenshots are for reference only and may differ from the actual design.
• If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message
"Out of Range" displayed on the background screen. Please change to an input signal which is compatible with
the projector's resolution or set the input signal to a lower setting. See
• If no signal is detected for 3 minutes, the projector automatically enters saving mode.
• If "Reset All Settings" is selected, setup wizard will appear after reboot, and Auto Source will be reset to default
value.
/SOURCE to select your desired input signal. See Switching input signal on page
Timing chart on page 53.
Operation 21