Using The Supplied Accessories; Use - Miele Classic C1 Flex Operating Instructions Manual

a AirClean
b Active AirClean 30 (black)
c HEPA AirClean 30 (white)
If your vacuum cleaner is fitted with ex-
haust filter b or c, you need to activate
the timestrip® filter change indicator.
 Pull the release catch for the dust
compartment lid upwards and open
the lid as far as it will go (Fig. 08).
 Remove the indicator strip (Fig. 09).
 Press the timestrip® filter change in-
dicator on the exhaust filter (Fig. 10).
After approx. 10–15 seconds, a thin red
line will appear in the left-hand side of
the display (Fig. 11).
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
The timestrip® filter change indicator
shows the remaining functional life of
the exhaust filter. After approx. 50 op-
erating hours the display will be com-
pletely filled with red (Fig. 12). 50 op-
erating hours equates to approxim-
ately one year of use.

Using the supplied accessories

(Fig. 13 + 14)
 Dusting brush
 Upholstery nozzle
 Crevice nozzle
 Accessory holder for the three ac-
cessories supplied
Symbols on the holder show where to
attach the different accessories.
 Attach the accessories holder to the
hose connector socket at the top or
bottom of the suction hose. Make
sure it clicks into position.
Adjustable floorhead (Fig. 15)
The adjustable floorhead can also be
used for vacuuming the stairs.

Risk of injury caused by falling
vacuum cleaner.
You may be injured if the vacuum
cleaner should fall from the stairs.
When vacuuming stairs, it is best to
start at the bottom of the stairs and
move upwards.

Use

Unwinding the mains cable (Fig. 16)
 Pull the mains cable out to the re-
quired length.

Risk of damage due to overheat-
ing.
The mains cable may overheat after
a long period of use.
If vacuuming for longer than
30 minutes, the cable must be pulled
out all the way.
To rewind the cable
 Switch off at the wall socket and un-
plug it.
 Press the rewind foot switch. The
cable will rewind automatically.
Switching on and off (Fig. 17)
 Press the On/Off footswitch .
en
39